Montana Woodworks MWHCRDGSSL Operating instructions

Assembly Instructions for Small Pet Beds

Thank you very much for purchasing our heirloom quality pet bed Should you have any questions or need to

contact sales or support, please do not hesitate to contact our corporate offices at 888.889.3728 or via E-Mail at:

cs@montanawoodworks.com

Before beginning assembly please take a few moments to read the instructions carefully, understanding each step.

Likewise please also ensure that the hardware package contains the items as described here.

Tools Needed: 9/16 Inch Wrench/Socket, Mallet.

Parts List: (1 ea.) Headboard/Footboard Assemblies, (4) Side Rails, (2) Cross Supports, (1) Mattress Support,

(1) Mattress, (4) Wooden Hole Plugs

Hardware List: (4) 4” Lag Bolts, (4) Washers

Assembly Directions:

Step 1. Place headboard (headboard & footboard are interchangeable) assembly flat on soft, non-marring surface

with holes facing upward.

Step 2. Insert the four side rails into the four holes of the headboard, positioning the bottom side rail with holes

facing inward to accept cross supports.

Step 3. Insert cross supports into predrilled holes in side rails.

Step 4. Tap side rails gently until seated in headboard.

Step 5. Stand headboard/side rail assembly upright.

Step 6. Insert one lag with washer into predrilled holes on headboard and tighten until secure.

Step 7. Position footboard at end of side rails.

Step 8. Carefully insert side rails into corresponding holes on footboard.

Step 9. Insert one lag with washer into each predrilled hole on footboard and tighten until secure.

Step 10. Ensure all lag bolts are tight. Insert a wooden hole plug into each of the headboard/footboard holes and

tap gently into place.

Step 11. Place mattress support on top of cross supports. Place mattress on top of mattress support.

Your new pet bed is now fully assembled. Enjoy!

PROUDLY MADE IN THE U.S.A.

 Please Note: If you purchased your pet bed “ready to finish” special care must be taken to properly apply a high grade final finish

in a timely manner. Doing so will help protect your purchase from discoloration and damage caused by exposure to ultra-violet

light. See use and care instructions for further information. Failure to adequately protect item by the applications of a final finish

may void warranty.

This manual is also suitable for

Download PDF