Assembly Instructions for Small Pet Beds
Thank you very much for purchasing our heirloom quality pet bed Should you have any questions or need to
contact sales or support, please do not hesitate to contact our corporate offices at 888.889.3728 or via E-Mail at:
cs@montanawoodworks.com
Before beginning assembly please take a few moments to read the instructions carefully, understanding each step.
Likewise please also ensure that the hardware package contains the items as described here.
Tools Needed: 9/16 Inch Wrench/Socket, Mallet.
Parts List: (1 ea.) Headboard/Footboard Assemblies, (4) Side Rails, (2) Cross Supports, (1) Mattress Support,
(1) Mattress, (4) Wooden Hole Plugs
Hardware List: (4) 4” Lag Bolts, (4) Washers
Assembly Directions:
Step 1. Place headboard (headboard & footboard are interchangeable) assembly flat on soft, non-marring surface
with holes facing upward.
Step 2. Insert the four side rails into the four holes of the headboard, positioning the bottom side rail with holes
facing inward to accept cross supports.
Step 3. Insert cross supports into predrilled holes in side rails.
Step 4. Tap side rails gently until seated in headboard.
Step 5. Stand headboard/side rail assembly upright.
Step 6. Insert one lag with washer into predrilled holes on headboard and tighten until secure.
Step 7. Position footboard at end of side rails.
Step 8. Carefully insert side rails into corresponding holes on footboard.
Step 9. Insert one lag with washer into each predrilled hole on footboard and tighten until secure.
Step 10. Ensure all lag bolts are tight. Insert a wooden hole plug into each of the headboard/footboard holes and
tap gently into place.
Step 11. Place mattress support on top of cross supports. Place mattress on top of mattress support.
Your new pet bed is now fully assembled. Enjoy!
PROUDLY MADE IN THE U.S.A.
Please Note: If you purchased your pet bed “ready to finish” special care must be taken to properly apply a high grade final finish
in a timely manner. Doing so will help protect your purchase from discoloration and damage caused by exposure to ultra-violet
light. See use and care instructions for further information. Failure to adequately protect item by the applications of a final finish
may void warranty.
/
