Wattstopper
®
Lighting Control Panel Relays
Installation Instructions • Instructions d’Installation • Instrucciones de Instalación
No: 24257 – 11/16 rev. 1
Catalog Numbers • Les Numéros de Catalogue • Los Números de Catálogo: LCDP1, LCSP2
Country of Origin: Made in China • Pays d’origine: Fabriqué en Chine • País de origen: Hecho en China
DESCRIPTION
The LCDP-1 and LCSP-2 are relay modules for use with the LC8-120/277 panel. The
LCDP-1 is a double pole/single relay module. The LCSP-2 is a single pole/double relay
module. The modules are designed for easy installation within the LC8-120/277 panel.
MOUNTING THE RELAY MODULES
The relays for the LC8 are modular. They are designed for DIN rail mounting. To install
the modules:
1. Disconnect all power to the unit.
2. Place the module over the DIN rail with the terminal blocks to the right.
3. Hook the terminal side of the module DIN rail track onto the DIN rail.
4. Lower the module and press down until the opposite side of the module clicks to
the DIN rail.
5. After the module is attached to the DIN rail, slide the module down the DIN rail
until it makes contact with the power supply module.
6. Carefully push the relay module against the power supply module until the multi-
pin connector on the relay module fully mates with the matching connector on the
power supply module.
7. Repeat this process for all relay modules that are to be installed in the enclosure.
When properly installed, there should be approximately 1/16” space between
each module.
8. To remove a module, press release button and reverse the above procedure.
SPECIFICATIONS
LCDP-1
Ballast/LED Driver .....................................................20 A @ 208V
Ballast/LED Driver ....................................20 A @ 240V (2 Phase)
Ballast/LED Driver ....................................20 A @ 480V (2 Phase)
Motor .............................................................. 1 HP @ 208V/240V
Short Circuit Current Rating ........................ 14kA AIC @ 277 VAC
LCSP-2
Incandescent ................................................... 20 A @ 120V/277V
Ballast/LED Driver ........................................... 20 A @ 120V/277V
Motor .....................................................................1/2 HP @ 120V
Short Circuit Current Rating ........................ 14kA AIC @ 277 VAC
LCDP-1 LCSP-1
Pat. Pend.
Double Pole Relay Module
Energy Management Equipment Accessory
86WA
LED lit when
relay is on.
Line
Load
Line
Load
14000r4
800.879.8585
www.legrand.us
LCDP-1
480V (2Ø), 60Hz, 20A Ballast and LED
240V (2Ø), 60Hz, 20A Ballast and LED
208V, 60Hz, 20A Ballast and LED
240V/208V, 60Hz, 1Hp
14kA AIC @ 277 VAC
Use Copper Conductors Only
LED
Input1
Output1
Input2
Output2
To
Relay Module or
Power Supply Module
To Relay Module
Release
Button
Dual Single Pole Relay Module
LED lit when
relay is on.
Line
Pat. Pend.
14001r4
Line
Load
Load
LED lit when
relay is on.
AB
LCSP-2
Energy Management Equipment Accessory
86WA
Use Copper Conductors Only
120/277V, 60Hz, 20A
Tungsten, Ballast and LED
120V, 60Hz, 1/2 Hp
14kA AIC @ 277 VAC
LED
To Relay Module or
Power Supply Module
To Relay Module
Input1
Output1
Input2
Output2
LED
Release
Button
800.879.8585
www.legrand.us
800.879.8585
www.legrand.us/wattstopper
No. 24257 – 07/16 rev. 1
© Copyright 2016 Legrand All Rights Reserved.
© Copyright 2016 Tous droits réservés Legrand.
© Copyright 2016 Legrand Todos los derechos reservados.
Wattstopper warranties its products to be free
of defects in materials and workmanship for a
period of five (5) years. There are no obligations
or liabilities on the part of Wattstopper for
consequential damages arising out of, or in
connection with, the use or performance of this
product or other indirect damages with respect
to loss of property, revenue or profit, or cost of
removal, installation or reinstallation.
Wattstopper garantit que ses produits sont
exempts de défauts de matériaux et de fabrication
pour une période de cinq (5) ans. Wattstopper
ne peut être tenu responsable de tout dommage
consécutif causé par ou lié à l’utilisation ou
à la performance de ce produit ou tout autre
dommage indirect lié à la perte de propriété, de
revenus, ou de profits, ou aux coûts d’enlèvement,
d’installation ou de réinstallation.
Wattstopper garantiza que sus productos
están libres de defectos en materiales y mano
de obra por un período de cinco (5) años. No
existen obligaciones ni responsabilidades por
parte de Wattstopper por daños consecuentes
que se deriven o estén relacionados con el
uso o el rendimiento de este producto u otros
daños indirectos con respecto a la pérdida
de propiedad, renta o ganancias, o al costo
de extracción, instalación o reinstalación.
WARRANTY INFORMATION INFORMATIONS RELATIVES À LA GARANTIE INFORMACIÓN DE LA GARANTÍA
-
1
Legrand LC8-120/277 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: Legrand LC8-120/277 Guide d'installation
Related papers
-
Legrand FS-M1 Mask Installation guide
-
Legrand LCPS-120/277 User manual
-
-
-
-
-
-
-
-
