Scotts 72191-2 Operating instructions

Scotts
Brand
Scotts
Model
72191-2
Type
Operating instructions
10056091
8-17-2017 6:57 PM Steve Iacona / Steve IaconaSaved at Nonefrom iMac-17-1a by Printed At
Approvals
Client
Built At
Output At
Scale
Bleed
Trim
Viewing
Live
Vendor
Contact
Scotts
100%
100%
1” = 1”
8” h x 31.625” w 7.75” h x 31.375” w
7.75” h x 31.375” w 7.75” h x 31.375” w
None
[email protected]
Job info
8x8 4PANEL 8 PGfold_ OUTSIDE
Notes/Special Instructions
Art Director
Copy Editor
PM
None
None
None
Fonts
Hellix (Regular, Heavy)
Inks
Cyan, Magenta, Yellow, Black,
PMS Cool Gray 7 C, PMS 3288 C,
PMS 7447 C, PMS 356 C
Images
Grow_Potted_Drip_r1.ai (55%, 45%, 56.9%,
50%, 24.8%, -24.8%, 66%, -50%, 38.42%,
-38.42%, 102.25%, 103.86%), Sprayer_Kit_
Pieces_20170715_GREY_r1.ai (25%)
Fonts & Images
Step 3
Install Drip Emitters
Components needed
Bag 2
Loose in
the pack
Using your scissors, cut the Micro
Tubing where you intend to run a
Micro Dripper to a pot or planter.
Run the Micro Tubing up to your pot
or planter and use the installation
tool to twist and push the Micro
Dripper into the end of the Micro
Tubing.
Then, snap on the stake, and place
into pot or planter.
Repeat as needed using Bags 2 & 3.
Option A Once you are done installing
Micro Drippers, you can then push the
end plug onto the T-Joint Connector
to stop the water flow.
Warning - Installation tool has a
functional sharp point. Contact may
result in injury. Handle with care.
MS3072
Welcome to Gro
™
.
The Gro
™
ecosystem is a new way for you to manage
all things that grow. Gro
™
smart devices replace
guesswork with data by using sensors, controllers, and
pulling weather analytics. Gro
™
also o ers you more
ways to save time and reduce waste with precision
watering kits and nutrient delivery systems. All this is
pulled together in a family of beautifully simple apps
allowing you to control from anywhere.
Gro
™
. Bringing you more joy, fewer chores.
Want to add on to your kit?
Or access helpful videos and FAQs?
Go to mygro.com/drip
Care and Maintenance
To maintain system serviceability winterization is
recommended. Disconnect from the spigot, remove
hose connectors, and protect from frost and freezing
conditions.
Have additional questions?
Call: 1-855-377-7292
Email: mygro[email protected]om
Potted Drip Kit
Instructions for Use
© 2017 The Scotts Company LLC.
World rights reserved.
Option A
Insert Pointer
End into Tube
Twist and push
T:31.375”
T:7.75”
B:31.625”
B:8”
F:7.75”
FS:7.625”
F:7.875”
FS:7.625”
F:7.875”
FS:7.625”
F:7.875”
1005609_T51151_Gro Potted Drip Kit Quick Start Guide_OUTSIDE REV 8.16_r1.indd 1 8/17/17 6:58 PM
10056091
8-17-2017 6:51 PM Steve Iacona / Steve IaconaSaved at Nonefrom iMac-17-1a by Printed At
Approvals
Client
Built At
Output At
Scale
Bleed
Trim
Viewing
Live
Vendor
Contact
Scotts
100%
100%
1” = 1”
8” h x 31.625” w 7.75” h x 31.375” w
7.75” h x 31.375” w 7.75” h x 31.375” w
None
[email protected]
Job info
8x8 4PANEL 8 PGfold_INSIDE
Notes/Special Instructions
Art Director
Copy Editor
PM
None
None
None
Fonts
Hellix (Regular, Heavy)
Inks
Cyan, Magenta, Yellow, Black,
PMS Cool Gray 7 C, PMS 3288 C
Images
Grow_Potted_Drip_r1.ai (70%, 50%, 19.49%,
30%, 35%, 25%, 24.8%, -24.8%, 66%, 43.67%),
Sprayer_Kit_Pieces_20170715_GREY_r1.ai
(25%)
Fonts & Images
Component List
In the Pack
Bag 1
Quick Connect
Hose/Spigot Connector
Water Flow
Reducer & Filter x 1
Bag 2
Bag 3
Micro
Dripper × 4
Micro
Dripper × 4
Micro
Tubing Stake × 4
Micro
Tubing Stake × 4
End Plug × 1
End Plug × 1
T-Joint
Connector × 4
T-Joint
Connector × 4
Loose in
the pack
Micro
Tubing x 1
50 ft (15 m)
Installation
Tool x 1
Step 1
Connect to Water Source
Keep in mind where you will
need to place the tubing
to reach your plants, begin
laying out the Micro Tubing.
Tip: Lay your Micro Tubing
out in the sun for a few
minutes to soften it up
before assembling.
Step 2
Layout Micro Tubing
Plan Micro Setup
Watch Quick Start Video
Go to www.mygro.com/drip
Lay out Micro Tubing—put it in the
sun for a few minutes to help
soften it up.
Identify the spigot, timer, or
hose you want to connect to.
Gather additional tools: scissors.
Components needed
Bag 1
Loose in
the pack
Components needed
Loose in
the pack
Simply pull back the
coupling to slide on
Micro Tubing.
Option A
Your Existing
Garden hose
Timer
(Not Included)
Water Flow
Reducer & Filter
Micro Tubing
Spigot
Option B
Connect your Potted Drip Kit to a
water source using this diagram as
a guide.
Option A If you are planning
to use a timer to control your
system, attach it first to your
spigot or hose, and then attach
the Quick Connect Hose/Spigot
Connector to your timer.
Option B If you plan to use your
existing hose, attach your hose
to your spigot, and then attach
the Quick Connect Hose/Spigot
Connector to your hose.
Quick Connect
Hose/Spigot
Connector
T:31.375”
T:7.75”
B:31.625”
B:8”
F:7.875”
FS:7.75”
F:7.875”
FS:7.625”
F:7.875”
FS:7.625”
F:7.75”
1005609_T51151_Gro Potted Drip Kit Quick Start Guide_INSIDE rev 8.17_r1.indd 1 8/17/17 6:52 PM
  • Page 1 1
  • Page 2 2

Scotts 72191-2 Operating instructions

Scotts
Brand
Scotts
Model
72191-2
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents