Toro Rear Attach-A-Matic Kit Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Toro Rear Attach-A-Matic Kit Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
The T
oro Company – 1997
Printed in USA
All Rights Reserved
FORM NO. 3319–584 Rev. B
INSTALLATION
INSTRUCTIONS
PART
NO. 95–4220
REAR ATTACH–A–MATIC HITCH
Loose
Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Mounting bracket assembly
Mounting bracket
Lock nut .375–16
Carriage bolt .375–16 x 3.5”
1
2
4
4
Assemble Attach–A–Matic
Assembling
the Rear
Attach–A–Matic
Hitch
The rear Attach–A–Matic is mounted on the rear
axle of the tractor.
1. Push one bolt upward through the rear hole on
each side of the Attach–A–Matic, then through
a mounting bracket (Fig. 1).
m–3618
1
2
3
4
5
6
7
Figure 1
1. Attach–A–Matic
2. Facing
front of tractor
3.
Facing rear of tractor
4.
Mounting bracket
5.
Carriage bolt .375 x 3.5”
6.
Lock nut
7. Latch
2. Begin to thread a nut onto the end of the bolt
(Fig. 1).
Installation Instructions
2
3.
Place the Attach–A–Matic
under the rear axle
(Fig. 2), and rotate the mounting brackets over
the top of the axle to hold the Attach–A–Matic
in place.
4. Push the remaining two bolts upward through
the front holes on the Attach–A–Matic, then
through the remaining holes on the mounting
brackets. Thread a nut onto each bolt.
m–3434
1
2
3
4
Figure 2
1. Attach–A–Matic
2. Axle
housing
3.
Mounting nuts
4.
Release button
5. Tighten the nuts evenly on the bolts to hold the
Attach–A–Matic in place.
6. When mounting an attachment to the rear
Attach–A–Matic, press on the release button
(Fig. 2) and open the latches. Place the
attachment bar hitch into the Attach–A–Matic,
then close the latches (Fig. 3).
m–3505
1
2
3
4
Figure 3
1. Attachment
bar hitch
2.
Rear Attach–A–Matic
3. Rear
4. Latch
/