Sea gull lighting 14916RD-15 Installation guide

Type
Installation guide
Installation Instructions for
Traverse Mirage
1.0
990TRAVMIR
14916RD
RECESSED
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for wet locations.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.generationlighting.com
© 2019 Generation Lighting.All rights reserved.
The "Generation Lighting" graphic is a registered trademark of
Generation Lighting. Generation Lighting reserves the right to
change specifications for product improvements without notification.
SAVETHESE INSTRUCTIONS!
2
Install the provided #8-32 screws to the junction box leaving the heads of the screws exposed to mount the fixture.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Using the keyed slots compatible with your junction box, mount the fixture onto the screw heads, and rotate clockwise to
lock in place. Fully tighten the screws to secure the fixture.
Insert the diffuser into the slots on the fixture then rotate clockwise to secure in place.
For wet locations, caulk around the base of the fixture with waterproof constructions sealant.
Install the Fixture
1
2
3
4
5
DIFFUSER
1A
JUNCTION BOX
4
2
3
#8-32 SCREW
FIXTURE
KEYED SLOTS
1
1
6
6
7
7
  • Page 1 1
  • Page 2 2

Sea gull lighting 14916RD-15 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI