www.PyleUSA.com2 www.PyleUSA.com 3
IMPORTANT SAFETY INSTRUCTIONS
1. Read and keep these instructions.
2. Heed all warnings.
3. Follow all instructions.
4. Do not use this apparatus near water.
5. Clean only with a dry cloth.
6. Do not block any ventilation openings. Install in accordance with the manufac-
turer's instructions.
7. Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarised or ground plug:
A polarised plug has two blades with one wider than the other.
The wide blade is provided for your safety. When the provided plug does not t
into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plug,
convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specied by the manufacturer.
12. Unplug this apparatus during lightning storms or when unused for long
periods of time.
13. Refer all servicing to qualied service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed t rain or moisture, does not operate normally, or
has been dropped.
14. To reduce the risk of re or electric shock, do not expose this apparatus to rain
or moisture.
15. Apparatus should not be exposed to dripping or splashing and no objects lled
with liquids, should be placed on the apparatus.
16. Use only with the battery which specied by manufacturer.
17. The power supply cord set is to be the main disconnected device.
WARNING
This symbol indicates that dangerous voltage constituting a risk of
electric shock is present within this unit.
This symbol indicates that there are important operation and
maintenance instructions in the literature accompanying this unit.
Introduction
PBKSP22 were designed for those seeking great audio experience from their
PC speakers with limited space in mind at the same time. Provides excellent sound
performance and it’s classical outlook makes it a perfect match for any environment.
Speakers are enclosed in MDF board cabinets that oer great acoustics for the set.
Sound control panel was placed on the side of one of the satellites which provides
easy access to the knobs located on that panel.
Installation
Before you begin the installation make sure that the main power switch is in
OFF position and all control knobs are in the maximum left position
(rotate it counter-clockwise).
1. Place the speakers such that the active speaker is on the right side. To achieve
best stereo eect listener and satellite speakers should form equilateral triangle
(each satellite should have the same distance from the listeners ears). Preferably
try to put the speakers in such manner that the tweeter speakers are on the same
height as your ears.
2. Connect the signal cable suitable for your sound source either with the Mini-Jack
3.5mm plug to the appropriate output port of your sound source (for example
output of your PC’s soundcard).
3. Connect the 2-wire cable to the “Speaker output” on the back of the active
speaker and to the socket on the back of passive speaker.
4. Connect the power plug to the mains socket.
5. Switch main power switch to ON position.
6. Start playing sound using your connected sound source.
7. Using the volume knob set up desired volume level.
8. You can adjust the played sound tones using the Bass and Treble knobs to suit
your personal performances.
Wireless BT Function
The speaker connects to your compatible BT-enabled device. Allowing the system
to receive your wireless Wireless BT signal and stream audio to any connected
speaker systems. Press the ‘Mode’ button on the rear panel of the speaker.
Ensure Wireless BT ability is activated on your device and search for the Wireless BT
Network Named: ’PBKSP22’ and connect. No password is required for connecting.
