Install TV plate and fixed wreath
STEP1
STEP2
Installation guide
Item No.:ABL-DLB211-SR
Fitting the bottom support on the desk
M4x12MM
A(4PCS)
M5x12MM
B(4PCS)
M6x20MM
C(3PCS)
M6x10MM
D(2PCS)
4x4mm
F
4
6
C
F
D
E
SK
Please select the appropriate
mounting holes according to
the thickness of desk
1 2 3
1
2
2.5X2.5mm
！
WARNING
Make sure the screw here
is tightly locked before
hanging up the screen
10 "-30"
10kg
75×7 5
10 0×100
-85°~15°
7
D
F
8
2
4
6
D
C
7
1
3
5
8
2.5x2.5mm
1.Tube cover (1PCS)
7.Adjustable clamp (1PCS)
2.TV plate (1PCS)
6.Bottom support (1PCS)
4.Tube (1PCS)
3.Fixed wreath (1PCS)
5.Cable cover (1PCS)
8.Anti-Slip rubber (1PCS)
9.Cable management clips (2PCS)
10.Decorative cover(2PCS)
4X4MM
F(1PCS)
5X5MM
G(1PCS)
9
10
1
2
3
4
For desk thickness
20-100mm
10
10
Washers
E(8pcs)
Not included
STEP4
Adjusting screen
CAUTION
This product contains small items that could be a choking hazard if swallowed. Keep these items away from young children.
● Make sure these instructions are read and completely understood before attempting installation. If you are unsure of any part of this installation, please contact a professional
installer for assistance.
● The desk or mounting surface must be capable of supporting the combined weight of the mount and the display, otherwise the structure must be reinforced.
● Please check joint parts every two months, and tighten screws where necessary.
This product was designed to be installed on desk. Before installing, make sure the mount will support the combined load of the equipment and
hardware. Never exceed the maximum load capacity 10 KG, or else it may result in product failure or personal injury.
Note: this product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury.
STEP3
Attaching TV plate to screen
Use the supplied 5x5 allen key (G)
to adjust the monitor
5x5mm
G
A/B
-85°~15°
±180°
32
1
E
A/B
E
G
5
Cable
9
Use provided washers (E) to
secure screws, if required.
/
