10
TECHNICAL FEATURES
Fig. C-5 On (play mode)/Off/Mp3 (I / O / II) lever switch
Diag. C-6 Button to change the music
Diag. C-7 Battery compartment cover
Diag. C-8 Mp3 player compartment safety latch
Diag. D-9 Ring to tie the hanging toys with fabric tapes to
Diag. D-10 Lamp with fading light effects
INTRODUCTION TO THE TOY
New padded play mat with attractive patterns and bright colours. It is fitted with a toy bar and electronic activity panel
providing babies with an endless range of activities: 7 multi-activity hanging toys and a soft hedgehog shaped pillow.
The electronic activity panel has a multi-coloured lamp with fading light effects, 20 minutes of music, pre-recorded
sound effects and an Mp3 player (not included in the pack) connector slot to accompany babies whilst playing or
relaxing.
HOW TO USE THE TOY
PLAY MODE
Switch the toy ON by pushing the ON /OFF lever switch (Diag. C-5) to I.
In this mode, the pre-recorded tunes will play for about 20 minutes. Every time your baby interacts with the panel
activities, this will add some entertaining sound effects to the music being played.
MP3 MODE
Push the ON /OFF lever switch (Diag. C-5) to II.
Open the Mp3 player compartment by turning the safety latch slightly (Diag. C-8). Turn the Mp3 player ON, select
PLAY and set the required volume. Connect the device to the connection cable, place the Mp3 player inside the
compartment and make sure it is firmly closed.
When this mode is selected, the child can listen to his favourite playlist. Every time the baby interacts with the panel
activities, this will add some entertaining sound effects to the music being played.
In order to avoid using up the batteries for no reason, it is recommended to switch off the toy by moving the switch to
O (Diag. C-5) when not in use.
Moreover, the music will play in Mp3 mode for around 20 minutes before switching to stand-by mode.
When in stand-by mode, if the baby touches the hanging toys, this will trigger some entertaining sound effects and the
Mp3 player will play some more music for another 10 minutes.
FITTING AND/OR REPLACING BATTERIES
· ATTENTION!
Batteries must only be replaced by an adult.
To replace batteries: loosen the screw on the battery compartment cover (Diag. C-7) with a screwdriver and open the
cover. Then remove the spent batteries and fit new ones, ensuring that they have been fitted with correct polarity (as
shown on the product), close the battery cover, and tighten the screw.
· Only use alkaline batteries of the same type or equivalent to the type recommended for the correct function of this
product.
· Never mix alkaline, standard (zinc-carbon) or rechargeable (nickel-cadmium) batteries.
· Never mix new and old batteries.
· Always keep batteries and tools out of the reach of children.
· Do not short-circuit the battery terminals.
· Always remove spent batteries from the toy to avoid the danger of leakage from the battery damaging the product.
· Always remove the batteries if the product will not be used for a long period of time
· Remove the batteries from the toy before disposing of the product.
· Do not burn or dispose of old batteries into the environment. Dispose of them at an appropriate differentiated
collection point.
· If the batteries happen to leak liquid, replace them immediately, making sure you clean the compartment beforehand;
wash your hands thoroughly if you come into contact with any such liquid.
· Do not attempt to recharge non-rechargeable batteries: they might explode.
· The use of rechargeable batteries is not recommended as the toy may not work properly.
· If using rechargeable batteries, remove them from the toy before recharging them. Batteries must always be recharged