2. Zonit
  3. Z-Lock

Zonit Z-Lock Operating instructions

  • Hello! I've reviewed the instructions for the Zonit zLock power cord. This document details how to connect and disconnect the cord's male and female ends, along with key features such as its locking mechanism and PDU style receptacle compatibility. I'm ready to answer any questions you may have about it.
  • How do I release the female end of the cord?
    What is the first step for connecting the male end of the cord?
    How much do I tighten the nut on the male end?
    Can I connect the male and female ends of the zLock cord to each other?
    What is the purpose of aligning nuts as shown in illustration 6?
Zonit Structured Solutions | 1790 30th Street, Suite 140, Boulder, CO 80301 | www.zonit.com
© 2017 Zonit Structured Solutions LLC | All Rights Reserved
Instructions
Insert cord
firmly into device
Cord is now locked To release, pull on either
of the red tabs and
remove cord
Cord will detach
from device
1 2 3 4
Ensure nut is backed out
as far as possible
Insert cord
firmly into device
Push and tighten the nut to initial
resistance, then add 1/4 to 1/2
turn to secure.
(Do not over-tighten)
Cord is now locked. Visually
inspect to be sure connector
is fully inserted
1 2 34
FEMALE END
MALE END
To release, loosen nut
as far as possible
Cord will detach
from device
5 6
Do not connect the male and female
ends of the zLock cord to each other.
Damage may result. The male plug
end should only be inserted into a
PDU style recessed receptacle.
Align nuts as shown to maximize
clearance in ganged receptacles
/