LAVEX INDUSTRIAL Stainless Steel Wall Mount Receiving Desk User manual

Type
User manual
WALL MOUNT RECIEVING DESK
ASSEMBLY INSTRUCTIONS
08/20221
1
1
A
B
C
E
DF
G
H
A
B
C
D
F
G
H
E
WALL MOUNT RECIEVING DESK
ASSEMBLY INSTRUCTIONS
PARTS
( 1 ) Top Storage Compartment
( 1 ) Top Cover Plate
( 1 ) Drawer Box
( 2 ) Supporting Bar
( 4 ) M6 x 12mm Cross
Recessed Flat Head Screw
( 4 ) M6 Flange Nut
( 4 ) M6 Flat Washer
( 1 ) MS743 Lock
1
Put the drawer box on a flat platform. Put the
top cover plate on the drawer box and align
the holes of the top storage compartment,
drawer box, and the top cover plate (figure 1).
Insert the M6 x 12 cross recessed pan head
screws from outside. Install flat washers and
flange nuts inside. (Turn up the top cover
plate when installing the screws, flat washers,
and the nuts.
See figure 2).
Top Storage
Compartment
Top Cover Plate
Flange Nut
Flat Washer
Cross Recessed
Flat Head Screws
Drawer Box
Figure 1
Figure 2
Install the supporting bar to
the bottom of the drawer box
with cross recessed pan head
screws.
See figure 3 & 4.
Flat Washer
Flange Nut
Supporting Bar
Cross Recessed
Flat Head Screws
Figure 3
Figure 4
1 08/2022
2
1
WALL MOUNT RECIEVING DESK
ASSEMBLY INSTRUCTIONS
3
The Hole of Top Storage Compartment
Fix the holes on the other end of
the supporting bar and the holes
on the back of the storage com-
partment onto the wall.
Holes on the Other End of the Supporting Bar
Figure 5
Figure 6
ASSEMBLY COMPLETE
2 08/2022
  • Page 1 1
  • Page 2 2

LAVEX INDUSTRIAL Stainless Steel Wall Mount Receiving Desk User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI