Fully charge Kick for at least 2 hours through a
wall outlet before first use (see step ➋).
To recharge Kick
Insert the supplied USB 2.0 cable (micro USB
end a) into Kick’s 5V input port b. Insert USB
end of cable c into the USB 2.0 port of your
wall adaptor, laptop or PC d.
QUICK START GUIDE
KICK Personal Bluetooth Speaker
For more information visit www.3sixtgear.com/support
1
2
3
a
c
d
d
Important Safety Information
PLEASE READ BEFORE OPERATION
1. Before recharging Kick through a
wall outlet make sure wall outlet
voltage is 5V.
2. Make sure to use a standard USB
2.0 Charge & Sync Cable with the
appropriate specifications - other
cables may damage your smartphone,
tablet or Kick.
3. Do not drop, knock, dissasemble or
aempt to repair Kick.
4. Do not immerse or put Kick in water
and keep Kick in a dry place.
5. Do not expose Kick to excessive heat
including sunlight and fire.
6. Do not use Kick near explosive gases
or flammable materials.
7. Do not burn or incinerate Kick.
8. Do not expose Kick to harsh
chemicals.
9. Turning Kick’s volume up to the max
shortens the life of Kick. It also may
damage your hearing.
10. Puing anything in Kick’s input or
output ports, other than a standard
USB 2.0 charge & sync cable will
cause damage or short out Kick.
11. When encountering any fault during
operation, please cut o the power
supply and disconnect the USB cable
to prevent further damage to the
speaker or other components.
12. The Bluetooth transmission range or
connectivity could be aected by low
baery power. In that case, recharge
immediately.
3S-0336/0337/0338/0339
b
e
h
Bluetooth Audio
• Press e for four seconds to
enter Bluetooth Mode.
• Press e for 1 second to
pause/play.
• When the speaker is in standby,
press e for 4 seconds to
change between Bluetooth and
AUX Mode.
Speakerphone
• Press e to pick up or hang
up an incoming call (while in
Bluetooth Mode only).
• Press e for 2 seconds to
reject a call.
Pairing Kick for the first time with your device
Enable your device’s (eg. smartphone or tablet)
Bluetooth. Slide the Power Buon h to ‘ON’
to turn Kick on. It will make a sound and the
Bluetooth/Speakerphone buon e will flash blue.
Hold down the Bluetooth/Speakerphone buon
e for 4 seconds and wait for a tone. Kick should
appear in your device’s paired devices list. ‘Pair’
your device with Kick. Kick will then make another
tone to confirm the pairing. You are now free to
play music & audio through Kick. Adjust the volume
of Kick through your device’s volume seings. For
every pairing aer your first, you only need to turn
on your device’s Bluetooth, turn on Kick and hold
down Bluetooth/Speakerphone buon e for 4
seconds. See tips adjacent for other buon uses.
1
