材质
铜版纸
产品名称 物料名称
印刷色
加工工艺
风琴 5折页，正反印刷
型号 物料编号
接合方式 /
成品尺寸
展开图尺寸：
公差： ±1mm
正面展开图
背面展开图
5
17
19
20 21
18
22 24
25 26
23
27 28
Remote controller button function
Upper and Lower limited position reset
Please scan the QR code
for detailed remote
controller instructions
The adapter is not
included in the
package
1
1x 1x
4x 4x
1x
1x
1x
2x
Roller
1x
234
13
2
1
2
41
23
1
2
4
5
2x
11
68 97
5
12
Roller
FCC statement:
"This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation."
"This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help."
FCC Caution:
"Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to
operate the equipment."
FCC RF Radiation Exposure Statement Caution: This Transmitter must be installed to provide
a separation distance of at least 20 cm from all persons.
1.Please read the specification carefully before installation or use.
2.Please install and adjust the product by professionals.
3.Warning the user that the appliance must be disconnected from the source of supply
before attempting the installation of the accessory.
1.Veuillez lire attentivement les spécifications avant de les installer ou de les utiliser.
2.Veuillez installer et ajuster le produit par des professionnels.
3.Avertir l’ utilisateur que l’ appareil doit être déconnecté de la source d’ alimentation avant
de tenter l’ installation de l’ accessoire.
RSS-Gen & RSS-210 statement:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionne-
ment.
This equipment complies with Industry Canada radiation exposure limits set forth for an
uncontrolled environment.
Cet équipement est conforme à l'exposition aux rayonnements Industry Canada limites
établies pour un environnement non contrôlé.
Cet émetteur doit être installé pour fournir une distance de séparation d'au moins 20 cm de
toute personne.
RSS-102 Statement:
"This equipment complies with Industry Canada radiation exposure limits set forth for an
uncontrolled environment. "
"Cet équipement est conforme à l'exposition aux rayonnements Industry Canada limites
établies pour un environnement non contrôlé. "
2x
Specifications
Blinds
Min Length: 60 cm / 23.6 inch
Max Length : 305 cm /120 inch
Min Width: 60 cm / 23.6 inch
Max Width : 140 cm / 55.1 inch
Remote control
Note: Reverse battery polarity will damage the remote control !
RS2004
Modulation ASK
Transmit frequency 433.92MHz±75KHz
Battery model AAA BATTERY X 2pcs
Transmit channel: 4 4
C2002
Wireless Protocol
USB-C Charger Input DC 5V/1A
Zigbee 3.0 (for gateway) and RF433Mhz (for remote controller)
Torque fore 0.4Nm
RPM 25
Tools are not included
packing list Ceiling installation
Walling installation
Adjust the position of bottom rail
Adjust the position of bottom rail Walling installation
Learning
Long press Long press
20
Upper Limit setting
2
3
1
2
3
Changed upper limit
Original upper limit
Lower Limit setting Reset the limited position Battery charging
Changed lower limit
Original lower limit
1
141312
10
16
15
Pairing the remote controller
1
2
3
1
Blueant X3 Portable Bluetooth Speaker User manual
Autel ADAAS IA900 User guide
Satechi TCAW7CM User manual
Contour DONGLE52 User guide
RP LIGHTING FANS 18042 User guide
Champion Power Equipment CPEKEY01 User manual
Satellite Electronic 18033 User manual
SATELLITE 18036 User manual
Kangtai 51196USA Wireless Remote Control Socket User guide
Insignia NS-PCY5BMA2 | NS-PCY5BMA2-C Quick start guide
