Champion Power Equipment CPEKEY01 User manual

CPEKEY01
Brand
Champion Power Equipment
Model
CPEKEY01
Type
User manual

Champion Power Equipment CPEKEY01 is a wireless remote control key designed for engine control. It operates on a 433MHz frequency and has a theoretical range of up to 80 meters in open areas. The device features two buttons: "START" and "STOP" for controlling the engine start and stop functions, respectively. Two green LEDs indicate when the buttons are pressed.

Champion Power Equipment CPEKEY01 is a wireless remote control key designed for engine control. It operates on a 433MHz frequency and has a theoretical range of up to 80 meters in open areas. The device features two buttons: "START" and "STOP" for controlling the engine start and stop functions, respectively. Two green LEDs indicate when the buttons are pressed.

CPEKEY01
CPEKEY01
Remote Controller
User Manual
CPEKEY01
IC Caution.
- English:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2)
This device must accept any interference, including interference that may cause undesired operation
of the device.
- French:
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
FCC Caution.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between theequipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in po
rtable exposure condition without restriction.
CPEKEY01
1. Descriptions
CPEKEY01 is an electronic key for engine wireless remote control. It’s a learning
remote-controller and based on 433MHZ center frequency. Its theoretical remote
distance can reach approximately 80 m in the open air.
2. Specifications
Work Voltage：DC 6V
Work Freqency：433MHZ
Work Range: <80m, depend on surroundings and corresponding receiver.
Working Temperature: -15 ~ 50℃
Storage Temperature: -40 ~ 70℃
Relative humidity: Max. 95 %
3. Operation
Key 1# “START” transmit a remote signal to receiver to control the engine start.
Key 2# “STOP” transmit a remote signal to receiver to control the engine stop.
The two green LEDs will be lightened when Key1# or Key2# pressed.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Champion Power Equipment CPEKEY01 User manual

CPEKEY01
Brand
Champion Power Equipment
Model
CPEKEY01
Type
User manual

Champion Power Equipment CPEKEY01 is a wireless remote control key designed for engine control. It operates on a 433MHz frequency and has a theoretical range of up to 80 meters in open areas. The device features two buttons: "START" and "STOP" for controlling the engine start and stop functions, respectively. Two green LEDs indicate when the buttons are pressed.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Other documents