Legrand WSME Series Enhanced Power Base Installation guide
- Type
- Installation guide
Wiremold
®
WSME Series Power Base
Installation Instructions
No: 1 010 852 – 0312
Catalog Number(s): WSMEUTBK, WSMEUTSL, WSMEDUTBK, WSMEDUTSL
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire hazard if improperly
installed or used. Legrand/Wiremold electrical products may bear the mark
of a Nationally Recognized Testing Laboratory and should be installed in
conformance with current local and/or the National Electrical Code.
Country of Origin: Made in U.S.
5 1/4" x 3"
[133mm x 76mm]
1. Provide 5.25" x 3" [ 133mm x 76mm] cutout at
location Power Base will be mounted.
2. Attach Power Base to surface from underside using 6
screws (not included) as shown in Figure 1.
3. Connect power cables as shown in Figure 2.
4. Connect data jacks, if provided, as needed.
Power Box
© Copyright 2012 Legrand All Rights Reserved.
Installation Instructions • Instrucciones de Instalación • Notice d’Installation No:
60 Wodlawn Street
West Hartford, CT 06110
1.877.BY.LEGRAND (295.3472)
www.legrand.us
570 Applewood Crescent
Vaughan, ONT L4K 4B4
905.738.919 5
www.legrand.ca
Wiremold
60 Wodlawn Street
West Hartford, CT 06110
1.800.621.0049
-
1
-
2
Legrand WSME Series Enhanced Power Base Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Legrand 25AM10FO FiberReady Entrance Fitting for Tele-Power Pole Systems 25DTP and AMDTP Series Installation guide
-
-
-
-
-
Legrand OFRPT4 Installation guide
-
Legrand EFB6S Installation guide
-
-
-