Sanus Systems EFB User manual

Assembly Instructions for Model: EFB

Assemble your Sanus Systems Model EFSat, or HTB Speaker Foundation,

attaching the L-Bracket. You will need the EFB Universal Mounting Bracket (sold

separately) to mount the speakers.

Use a Phillips screwdriver to remove the two plastic wall spacers that are on the

back of your speaker, located just above the speaker terminal

plate.

Pull the speaker wires through the wire management and

connect them to your speaker; then, lay the speaker down with

the back facing up.

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 2.03.06 (100007)

Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com

Speaker

Wires

Open the EFB Package and remove the small Black Spacers and place them over

the holes in the back of your speaker where the two plastic wall spacers were

removed.

Align the top two slots of the EFB over the two small Black Spacers.

Using a Phillips screwdriver, and the two Screws provided with the EFB, secure the

EFB and Spacers to the speaker, taking care as to not overtighten the screws.

EFB

Screws

Spacers

Slide the Speaker and EFB onto the L-Bracket on the stand.

EFB

L-Bracket

Speaker