Alvarez ACM50 Installation Instructions Manual

Brand
Alvarez
Model
ACM50
Type
Installation Instructions Manual
1. Remove the two flathead screws
fastening the System 600T MKII.
Remove the module from the
instrument. (Do NOT remove the
four small Phillips screws on the
System 600T MKII bracket ring.)
2. Using the spring clip, attach the
ACM50 to a back brace. Position
the mic to taste. Some players prefer
facing the mic towards the soundhole/
strings to pick up the direct string
sound. Others prefer to position the
microphone to reproduce the internal
sound of the guitar.
3. Plug the 3.5mm stereo plug from the
Alvarez ACM50 into the AUX input
on the back of the System 600T MKII.
(The ring of the plug supplies power
to the microphone.)
4. Reinstall the System 600T MKII while
making sure all connections are intact
and all excess wire is not obstructing
the functions of the instrument.
5. Set the LEVEL control to -20. If the
level control is set to 0dB, distortion
may occur.
6. Using the AUX control on the System
600T MKII, adjust the gain to the
desired setting relative to the level of
the bridge Piezo pick-up.
7. Use the Master Volume control to set
combined level.
PIEZO
Cutaway view of
inside-back of guitar
AUX
OUTPUT
INSTALLATION INSTRUCTIONS
  • Page 1 1
  • Page 2 2

Alvarez ACM50 Installation Instructions Manual

Brand
Alvarez
Model
ACM50
Type
Installation Instructions Manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents