Privileg TWS951CGG2 Program Chart

Type
Program Chart

This manual is also suitable for

1. Control panel
2. Upper basket (area for freezing)
3. Ice tray and/or cold accumulator
4. Baskets for storing frozen food
5. Rating plate
6. Pull-out defrost water drain
7. Freezer compartment door
Storage compartment
Area for freezing
Note:
- In case of power failure the cold accumulator helps to
keep optimal storage temperature longer.
- The design of baskets and accessories may vary,
depending on the model.
- All baskets, the ice tray are removable.
Important: Freezer accessories must not be washed
in a dishwasher.
Note: Ambient air temperature, the frequency of door
opening and the position of the appliance can affect the
freezer internal temperature.
These factors must be taken into account when setting the
thermostat.
The freezer is switched on by means of the thermostat
located on the tabletop.
Freezer control panel
Min
Max
Off
ABCDE
Indicator LEDs
A. Knob of the control.
B. The green LED indicates that the appliance is
connected to the power supply.
C. The red LED shines or blinks indicating alarm for
critical temperature within freezer (it is above -12°C) or
damage sensor of freezer.
D. The yellow LED lights up when the fast freeze button
is pressed or blinks together with red LED indicating
damage sensor of freezer.
E. Fast freezing (push button) - fast freeze function is
selected, yellow indicator lamp (D) switches on.
Fast Freezing function
The use of this function is recommended when placing
a very high quantity of food to be frozen. 3 hours before
freezing fresh food, press Fast Freezing button (E). After
3 hours place the food to be frozen in the upper basket
– area for freezing (2). This function is automatically
disabled after 24 hours, or can be manually disabled by
pressing Fast Freezing button (E).
Freezer internal temperature control
Thermostat set to Min: internal temperature least cold
Thermostat set to Max: internal temperature coldest
Thermostat set to Off: switches off the freezer
compartment only (the appliance remains connected to
the power supply).
Recommended thermostat setting: Med position.
Alarm signal
Signal Cause Solution
The red LED (C)
lights up
The internal
temperature is
above -12°C
Press button
(E) until the
temperature
returns below
-12°C again (the
red temperature
alarm LED will
switch off).
5019 620 00034
FIDKNOSEGRITPTESNLFRGBDE
PRODUCT SHEET
EN
  • Page 1 1

Privileg TWS951CGG2 Program Chart

Type
Program Chart
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI