LADEN WAT 9555D Program Chart

Brand: LADEN

Model: WAT 9555D

Category: Washing machines

Type: Program Chart

This manual is also suitable for

WAT Stuttgart

WAT 9555 D

5019 100 12642

N.B. This appliance is controlled by sensors. The excess of detergent in the dispenser could cause technical problems

Programme Type of fabrics / Degree of soiling / Notes Max.

Load

Detergent and Additives Options Temperature

°C

Spin Speed

rpm/min

Pre-

wash

Main

Wash

Softener Bleach Pre-

wash

Intensive

Rinse

Hold

Spin

speed

reduction

Start

Delay

Cotton

Katoen

Averagely soiled, hard wearing and temperature stable textiles in cotton and

linen (bed linen, table linen, underwear, shirts etc.). The max load for heavily

soiled laundry is 3.5 kg.

5.0 Yes Yes

❉❉❉❉❉❉❉

95 min. to 1200

Cotton

Katoen

Averagely soiled, hard wearing and temperature stable textiles in cotton and

linen (bed linen, table linen, underwear, shirts etc.).

5.0 Yes Yes

❉

—

❉❉❉❉❉

30-40-60 min. to 1000

Synthetic

Synthetische

weefsels

Lightly or averagely soiled blouses, skirts, etc. made of polyester (Diolen,

Trevira), polyamide (Perlon, Nylon) or cotton blends.

2.5 Yes Yes

❉

—

❉❉❉❉❉

30-40-60 min. to 1000

30 min / 30°C

Lightly soiled outer garments and sportswear made of cotton, polyester,

polyamide and cotton blend.

3.0

—

Yes

❉

—— —

❉❉❉

30 min. to 1200

Delicate

Fijne was

Delicate curtains, dresses, skirts, shirts and blouses. 1.5 Yes Yes

❉

—

❉

—

❉❉❉

30-40 min. to 1000

Wool

Wol

Only machine washable woollens with pure new wool label. If you select the

special function “Rinse Hold” do not leave garments to soak for too long.

1.0

—

Yes

❉

—— —

❉❉❉

Cold-30-40 min. to 1000

Hand Wash

Handwas

Silk and other textiles, which are labelled with “Handwash”.

For improved garment care the spin speed is restricted to 400 rpm. For no spin

select the option “Rinse Hold”. When the option light is flashing, turn the

programme selector to “Drain” and press the “Start” button.

1.0

—

Yes

❉

—— —

❉

—

❉

30 no spin to 400

Rinse + Spin

Spoelen +

centrifugeren

Programme for treating wash with starch or softener. Terminates with an

intensive spin cycle.

5.0

——

❉

—— —

❉❉❉

Cold min. to 1200

Spin

Centrifugeren

Programme for Intensive spin cycle. 5.0

———————

❉❉

—

min. to 1200

Intensive Spin

Intensief

Centrifugeren

Programme for gentle spin cycle. 1.5

———————

❉❉

—

min. to 1000

Drain

Afpompen

Drain only, without spin cycle. Alternative way of terminating programmes with

“Rinse Hold” setting.

— ——————— —

❉

——

PROGRAMME TABLE

30 min / 30° C

Hand Wash

A. Water tap indication

B. Programme sequence indication

C. Spin Speed Reduction button

D. Start button

5019 100 12642

Prewash cycle increases programme duration by 5 to 20 min. Consumption values were measured in normalized

conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in

the table in relation to the water supply pressure and temperature, the load and the type of wash.

The remaining time indicator can similary deviate from the values in the table, because it takes into account the

household conditions applicable at that time.

To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains

the water out.

ADDING DETERGENT AND ADDITIVES

Add the detergent and the additives into the dispenser as follows:

• Programme with pre- and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (water hardness 4)

Important:

• Be careful not to fill more than the

“MAX”

level mark.

• For programmes without prewash from cold to 40° C it is recommended to use a liquid detergent

to avoid whitish residues on the coloured laundry.

• With a Start delay, use a dose aid for liquid detergent, placed directly in the drum.

CLOSE THE DOOR AND SELECT THE PROGRAMME

1. Turn the

programme selector knob

to the desired programme with its predefined temperature.

The remaining time display shows the duration of the choosen programme (in hours and

minutes) and the pilot lamp of the “Start” button is flashing.

2. The programme sequence and the predefined spin speed indication corresponding to the

selected programme lights up.

PRESS ANY DESIRED OPTION BUTTON(S).

The pilot lamp lights up.

An audible tone sounds if the combination of programme and additional options is not

possible. Unsuitable combinations of options are deselected automatically

Prewash button

• Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases

from 5 to 20 min.

Intensive Rinse button

• For improved rinsing efficiency the rinse water level and the cycle time are increased.

• This option is particulary suitable for areas with very soft water washing baby linen and helps

people with allergies.

Rinse Hold button

• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid

creasing and prevent colours from changing.

• This option is particularly recommended for the programme “Synthetic” or “Delicate”.

• This function is particularly useful if you want to postpone spinning to a later time or when you do

not wish to spin the clothes.

Note

: The programme stops to “Rinse Hold” at the time the “Rinse Hold” button light flashes

Terminate the Rinse Hold option:

• Press the “Rinse Hold” button again; the programme will terminate automatically with the final

spin cycle for the present wash programme.

• If you do not wish to spin the clothes, turn the programme selector knob to the drain programme

and start again.

Spin speed reduction button

• Every programme has an automatic predefined maximum spin speed.

• Press the button to set another spin speed.

• If no lamps are on, the final spinning is cancelled.

Start Delay button

The Start Delay allows to run the machine at the consumer’s convenience, for example at night when

electricity is cheaper.

• Press the “Start Delay” button to select the delay time by 1 to 19 hours;

• Press the “Start” button. The “Start Delay” light flashes until the programme starts.

• The time delay indication disappears when the programme starts and it’s replaced by the

remaining time.

• The number of hours preselected can later be reduced pressing again the “Start Delay” button.

To cancel the “Start Delay”.

• Turn the programme selector to the “” position.

• Reselect the desired programme and options and press the “Start” button.

PROGRAMME START

Open the tap and press the “Start” button. The pilot lamp of the “Start” button lights up. The indicator

lamps show the sequence reached in the programme. After starting the programme, the sequence

indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is

finished the corresponding lamps goes out.

DOOR LOCK

During the running programme the door can be opened for adding further laundry.

The door locks automatically in all rinsing and spinning cycles. If the programme is stopped or the

electrical power supply is terminated, the door lock will open after approximately 1 minute.

PROGRAMME END

• The remaining time is on “0:00” and all the lights of the programme sequence indication are “Off”.

A short audible tone sounds three times.

1. Turn the programme selector to the position

“”

2. Turn the water supply tap off.

3. Open the door and the drum flaps and unload the machine.

SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER

PROGRAMME START

1. Press the “Start” button to pause the programme. The light flashes.

2. Select the new programme (with temperature), any options and another spin speed if you want it.

3. Press the “Start” button again. The programme continues at the same position of the programme

sequence indication. Do not add detergent for this programme.

TO STOP, RESET A PROGRAMME BEFORE THE END

1. Press the “Start” button to pause the programme. The lights flashes.

2. Set the programme selector to “Drain”. The spin indications are off and the remaining time shows

2 minutes.

3. Press the “Start” button to start the drain programme.

AUTOMATIC SAFETY FUNCTIONS / FAULTS

This washing machine is equipped with automatic safety functions which detect and diagnose faults

at an early stage and react appropriately. Often, however, the faults detected are small enough to be

solved in a matter of minutes. Informations can be found in the Troubleshooting guide.

CONSUMPTION DATA

Programme Temperature

Selector

(°C)

Rated

Load

(kg)

Water

(l)

Energy

(kWh)

Programme

Duration

(min)

Cotton 95

5.0 49* 1.6 125

Coloured Cotton 60 5.0 48 0.95 120

Synthetic 60 2.0 54 0.7 89

Synthetic 40 2.0 50 0.5 74

Express 30 3.0 35 0.4 30

Delicate 40 1.5 50 0.5 45

Wool 40 1.0 50 0.5 42

Handwash 30 1.0 35 0.4 25

LADEN WAT 9555D Program Chart

Brand: LADEN

Model: WAT 9555D

Category: Washing machines

Type: Program Chart

This manual is also suitable for

WAT Stuttgart

Download PDF

report

LADEN WAT 9555D Program Chart

This manual is also suitable for

LADEN WAT 9555D Program Chart

Related papers

Other documents