2. Niigata seiki
  3. DL-S2W

Niigata seiki DL-S2W, DL-S3, DL-S4W User manual

  • Hello! I've reviewed the owner's manual for the LEVELNIC DL-SL L-Base attachment and its compatible electronic levels. This document details the features of the L-Base, such as its ability to adapt electronic levels for vertical measurements, extend the base length, and provide a magnet with on/off switch. I can answer questions about its specifications, mounting, and compatible models. How can I help you today?
  • What is the purpose of the L-Base attachment?
    What is the increase in base length when attached?
    What is the purpose of V-Groove on measurement surface?
    What is included in the accessories?
    What models are compatible with this L-Base?
    What is the angle of V-Groove?
LEVELNIC L-Base ・ DL-SL　Owners Manual

 !"
FEATURES
#     $   "     "

!%&& $ （' 
 ()& *%&& $）
+"  ,"
  $ -.-// $      $  "
 （0$  "   $$-//）
SPECIFICATIONS
Base Dimensions: 200×255×55（mm）
Measurement Surface: 200×200×55（mm）
#12 $3（%&4.(&）（5）
#+"2 (6&7
Compatible Models: DL-S3・DL-S4W・DL-S2W
ACCESSORIES
M5×25 Cap Screws (x2), Wrench, Aluminum case, Owner's Manual.
MOUNTING
Figure 1, 2: Attach the compatible LEVELNIC onto the L-Base.
Figure 2: With the LEVELNIC in position, secure using the M5x25 (x2) cap screws.
NOTICE: ※Do not over-tighten the cap screws or the Base surface may be distorted.
・28!9$
Fig. 1 Fig. 2
Magnet ON・OFF Lever
M5×25
Cap Screws
WHEN USED WITH OPTIONAL DL-BW
When mounting the DL-BW, please install two spring washers between the DL-BW Mounting Bracket
and the DL-SL as shown in the drawing above. If the washers are left off, the gap will cause the DL-BW
to be unstable.
+::;-<
=()%%< <9<>))&&))?::
2&%)=6()=@&
Mounting Drawing
LEVELNIC Base
DL-BW Mounting Bracket
Spring Washer (×2)
M5×25 Cap screw
DL-SL Base
/