2. CMP
  3. Step Jet Kit

CMP Step Jet Kit Operating instructions

  • Hello! I've reviewed the instructions for the CMP Step Jet Kits, models 25591-910, 25591-911, 25591-930, and 25591-931. This document outlines the installation process, including properly installing the air and water lines. It also lists all the included parts. I'm ready to answer any questions you might have about the installation process, the parts included, or any other aspect of these jet kits.
  • How should the air line be installed?
    How to install water pipe?
    What size hole is needed for the jet?
CMP# 25591-910, 25591-911, 25591-930, 25591-931
WWW.C-M-P.COM
Step Jet Kits
1” Flex Pipe
(Air Line)
1-1/2” Plug
Jet
1” Plug
1-1/2” Flex Pipe
(Water)
Water Line
1-1/2”
1-1/2” Tee
Air Control
Air Control
1” Flex Pipe
(Air Line)
1” Plug
1-1/2” Flex Pipe
(Water Line)
1-1/2” Tee
1-1/2” Plug
Jet
TOP VIEW
SIDE VIEW
IMPORTANT:
Install air line so that it angles up from the jet without
sag. Any sag at all can cause the line to waterlog and
impair the performance considerably.
To install jet, place L-Gasket over threads of wall fitting
with the “L” lip away from the wall fitting flange. Place
fitting in a 2-5/8” hole on step with flange on inside of
pool. Run a bead of silicone around hole on outside of
pool then thread body onto fitting. Turn body as desired
then finish tightening by using the fitting wrench on the
fitting. Clean off any silicone left inside the pool.
PARTS INCLUDED:
1) Jets (2)*
2) Air Controls (2)
3) 1-1/2” Plugs (2)
4) 1” Plugs (2)
5) 1-1/2” Tee (1)
6) 3 feet of 1” Flex Pipe (2)
7) Winterizing Plugs & Fitting Wrenches (2)
8) Glue (1 can)
* Jet assembly is made up of a Body, Wall Fitting, L-Gasket, and a Jet Internal.
Install the Jet Internal after plumbing is completed.
®
/