PHOTOCELLS

CAT. NOS. PCIND, PCOUT, PCATR, PCSKY

INSTALLATION INSTRUCTIONS

WARNINGS AND CAUTIONS:

• TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT

POWER IS OFF BEFORE WIRING!

• To be installed and/or used in accordance with appropriate electrical codes and regulations.

• If you are unsure about any part of these instructions, consult an electrician.

• SAVE THESE INSTRUCTIONS.

WARNINGS AND CAUTIONS:

•

Read and understand all instructions. Follow all warnings and instructions marked on the product.

the purpose of lighting control. There are 4 different styles with 4 different

possible ranges for a total of 16 basic varieties.

All 16 varieties require a Class 2 Low Voltage Power Supply providing

12-24VDC input power to operate properly.

The four different styles of Leviton Photocells have different mounting and

installation requirements which are covered in the installation section.

INSTALLATION

Indoor Photocell – PCIND (Ceiling)

Indoor Photocell - PCIND (Reflecting Wall)

Mount the Indoor photocell at a reflecting wall. When sconces are in place in

the light well, make sure not to mount photocell in direct level as the sconces.

Place photocell 18” from the bottom corner of the ceiling. Remember, the

Fresnel lens will see light with a field of view that is 1.15 times the distance to

the wall. No direct lighting should be within the field of view. (See Figure 1C)

Outdoor Photocell - PCOUT

Mount the Outdoor photocell in a standard threaded 1/2” conduit or 1/2”

knockout. Locate the photocell on the roof or somewhere that is exposed

to full daylight and is not shadowed or directly exposed to any night-time

facing towards the Atrium glass. (See Figure 1B)

Skylight Photocell - PCSKY

Mount the Skylight photocell in a standard threaded 1/2” conduit or 1/2”

knockout. Locate the assembly near the center of the skylight well (at least

12” from the side) that is exposed to full daylight and is not shadowed. For the

best results, use uni-strut with a 1/4” angle support, making sure the top of

the light photocell is level with top of skylight curb. Photocell must be mounted

vertically with the domed portion facing up. (See Figure 1D)

ADJUSTABLE CORRESPONDING

FOOT-CANDLE RANGES

FACTORY SET MAX.

photocell.

When calibration is complete, be sure to replace the plastic screw and washer

to seal the hole from dust and water. If there does not seem to be enough

information here to adjust the photocell’s gain, you should rely on the factory

setting or call technical support for additional help.

NOTE: Field adjustment of the photocell’s gain is not recommended.

Leviton Photocells are functioning when the EMS system analog status

changes as the photocell detects light. Once calibrated, the photocell

will need no further attention. Except for the calibration hole there are no

switches or other user controls on the photocell.

Every 2 months wipe the lens clean with a non-scratching clean cloth and

FOR CANADA ONLY

For warranty information and/or product returns, residents of Canada should contact Leviton in writing at Leviton

Manufacturing of Canada Ltd to the attention of the Quality Assurance Department, 165 Hymus Blvd, Pointe-

Claire (Quebec), Canada H9R 1E9 or by telephone at 1 800 405-5320.

For Technical Assistance Call: 1-800-824-3005 (U.S.A. Only) www.leviton.com

LIMITED 5 YEAR WARRANTY AND EXCLUSIONS

Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that this product at the time of its sale by Leviton is free of defects in materials and workmanship under normal and proper use for five years from the

purchase date. Leviton’s only obligation is to correct such defects by repair or replacement, at its option. For details visit www.leviton.com or call 1-800-824-3005. This warranty excludes and there is disclaimed liability for labor for removal

of this product or reinstallation. This warranty is void if this product is installed improperly or in an improper environment, overloaded, misused, opened, abused, or altered in any manner, or is not used under normal operating conditions or not in

accordance with any labels or instructions. There are no other or implied warranties of any kind, including merchantability and fitness for a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration

C.B