Builders Edge 140110774016 Operating instructions

Brand: Builders Edge

Model: 140110774016

Type: Operating instructions

Fiber Cement Hooded Exterior Dryer Vent

Installation Instructions

-To be installed prior to siding-

Step 1

Remove the trim ring from the Hooded Dryer

Vent Assembly. See Figure 1 below.

Step 4

The top flange of the Hooded Mount should be shingled

underneath the building paper. If the building paper is

already installed, slice the paper so that the top flange of

the Mount can be slid up underneath the paper and seal

the cut in the paper with a strip of flashing tape. Cut the

siding around the Mount. Install the siding according to

the manufacturer's installation instructions. Caulk all gaps

as needed per the siding manufacturer's specifications.

See Figure 4 below.

Step 2

Place tape or sealant between the Hooded Dryer

Vent and house. Align the Hooded Dryer Tube

with the available opening (Suggested hole

size: 4 1/8" diameter.) See Figure 2 below.

Step 3

Attach the Hooded Dryer Vent in the desired

location with the arrows on the flange of the part

pointing up. Use an 8d nail or equivalent (to

include a #8 x 1" long or #8 x 1 1/2" long Zinc

Coated Screw) with a minimum of four attachments.

See Figure 3 below.

Step 5

Lock on the finishing trim ring. See Figures 5A and

5B below.

Figure 1

Figure 3

Figure 4

Figure 5A

Figure 5B

I-0144

06-17-08

PC 10629

Figure 2

Flashing Tape

Builders Edge 140110774016 Operating instructions

Builders Edge 140110774016 Operating instructions

Builders Edge 140110774016 Operating instructions

Related papers

Other documents