Assa Abloy EMTEK Tubular Monolithic Entry Set Installation guide

Brand: Assa Abloy

Model: EMTEK Tubular Monolithic Entry Set

Type: Installation guide

1. Door Prep 2. Door Jamb Prep

Installation Guide - Tubular Monolithic Entry Set - Single Cylinder Deadbolts

4. Outside Installation

Extension Collar is provided for thin doors.

5. Inside Installation

IN4-ENTSETSGMON 04-29-2013

2-1/4"

5-1/2"

2-3/8"

2-3/4"

1/8"

Deep

2-1/4"

1" Dia.

Edge Bores

2-1/8" Dia.

Bores

3/16”

Deep

2-3/4”

1-1/8”

1-1/4”

1/8”

Deep

After lock is

installed, tighten

set screw with

hex wrench

provided.

Plates and grips vary depending on style.

* Marretta 6 style locks have 6” center to center

bore spacing.

Install with tail piece

horizontal

Optional extension

collar for thin doors

Optional Dead

Bolt Collar

For Brass Only

Optional Dead

Bolt Collar

For Brass Only

2-1/8" Dia.

Bores

2-3/8"

2-3/4"

5-1/2"*

2-1/8" Dia.

Bores

2-3/8"

2-3/4"

No less

than

4-1/2"

Installation Instructions-Tubular Monolithic Entry Set - Dummy

*Marietta 6 style locks have 6” center

to center bore spacing.

Installation Instructions-Tubular Sectional Entry Set - Dummy

IN4-ENTSETDUMY

REV. 03/26/08

IMPORTANT:

Do not remove screws

AFTER LOCK HAS BEEN INSTALLED

Tighten Set Screws with Allen Wrench

AFTER LOCK HAS BEEN INSTALLED

Tighten Set Screws with Allen Wrench

Assa Abloy EMTEK Tubular Monolithic Entry Set Installation guide

Assa Abloy EMTEK Tubular Monolithic Entry Set Installation guide

Assa Abloy EMTEK Tubular Monolithic Entry Set Installation guide

Other documents