2. Assa Abloy
  3. EMTEK Tubular Monolithic Entry Set

Assa Abloy EMTEK Tubular Monolithic Entry Set Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Assa Abloy EMTEK Tubular Monolithic Entry Set Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1. Door Prep 2. Door Jamb Prep
Installation Guide - Tubular Monolithic Entry Set - Single Cylinder Deadbolts
4. Outside Installation
Extension Collar is provided for thin doors.
5. Inside Installation
IN4-ENTSETSGMON 04-29-2013
2-1/4"
5-1/2"
2-3/8"
or
2-3/4"
1/8"
Deep
2-1/4"
1"
1" Dia.
Edge Bores
2-1/8" Dia.
Bores
3/16”
Deep
2-3/4”
1-1/8”
1-1/4”
1/8”
Deep
After lock is
installed, tighten
set screw with
hex wrench
provided.
Plates and grips vary depending on style.
* Marretta 6 style locks have 6” center to center
bore spacing.
*
Install with tail piece
horizontal
Optional extension
collar for thin doors
Optional Dead
Bolt Collar
For Brass Only
Optional Dead
Bolt Collar
For Brass Only
2-1/8" Dia.
Bores
2-3/8"
or
2-3/4"
5-1/2"*
2-1/8" Dia.
Bores
2-3/8"
or
2-3/4"
No less
than
4-1/2"
Installation Instructions-Tubular Monolithic Entry Set - Dummy
*Marietta 6 style locks have 6” center
to center bore spacing.
Installation Instructions-Tubular Sectional Entry Set - Dummy
IN4-ENTSETDUMY
REV. 03/26/08
IMPORTANT:
Do not remove screws
AFTER LOCK HAS BEEN INSTALLED
Tighten Set Screws with Allen Wrench
AFTER LOCK HAS BEEN INSTALLED
Tighten Set Screws with Allen Wrench
/