MGP BNA-60S Installation guide

Brand: MGP

Model: BNA-60S

Type: Installation guide

Master Garden Products.

1-800-574-7248

Bamboo North Arbor (BNA-72) Assembly Guide

Included Hardware:

3” long hex screws (4)

1.5” long hex screws (8)

Hex tool (1)

Bamboo leg support pieces (total 4, 2 of each connecting pieces):

Bamboo roof pieces (2):

Bamboo corner bracers (4):

1. Setup up the leg supports first. It doesn’t matter which pair is matched but the end that

needs to slide into the hollowed section must be the larger diameter end. It should fit

snug if inserted correctly. Do this for the other pair.

2. Setup the arbor roof piece. Slide and match up the two roof pieces with the pre-drilled

holes. Using the hex tool and two 3” hex screws, secure the two sections to together on

both sides.

3. Slide the leg support piece onto one end of the just completed roof piece. The correct

end should be labeled with a numbered sticker. Make sure it’s locked in and slid all the

way through. Insert a bracer at the corner and use two 1.5” hex screws to secure it. Do

this for the remaining 3 corners. This should complete the arbor. Remove all stickers if

need be.

6. To properly secure the arbor to the ground, use stakes that can be purchased at your local

hardware store or other 3

rd

party source. Additionally, to increase the lifespan of the arbor, a

linseed oil or water proof polyurethane can be applied once every 3-4 years.

Thank you for your business! Any Questions? Call us at: 1-800-574-7248

1
2
3
4

MGP BNA-60S Installation guide

Brand: MGP

Model: BNA-60S

Type: Installation guide

Download PDF

Related papers

Other documents