Style Selections 3072 Installation guide

Brand: Style Selections

Model: 3072

Type: Installation guide

Style Selections 3072 is a 22" x 28" oval mirror with a mounting bracket and a 12" wall mounting clip. It comes with 3 plastic wall anchors, 3 screws, and a disposable level. To mount the mirror, you will need a pencil and eraser, a drill with a 3/16" drill bit, a screw gun or driver with a Phillips head, a tape measure, and a hammer.

Check the location where the mirror is to be installed. Make sure the mirror will fit in the desired location.
Place the mirror on the wall in the chosen area. Position the mirror at the desired height in the center of the location. Mark a dot or line on the very top edge of the arch.

Check the location where the mirror is to be installed. Make sure the mirror will fit in the desired location.
Place the mirror on the wall in the chosen area. Position the mirror at the desired height in the center of the location. Mark a dot or line on the very top edge of the arch.

WARNING: Always wear safety goggles and gloves when

handling glass. Handle mirror carefully. Do not bump mirror

against hard surfaces. Place on towel or soft surface such

as carpet when handling. READ INSTRUCTIONS CAREFULLY

BEFORE STARTING.

#2 Place the mirror on the wall in area chosen.

(Two people are needed for this task).

Position the mirror at the desired height in

the center of the location. With Pencil mark

a dot or line on the very top edge of the arch.

See (Fig.1) Set mirror aside In safe place.

#4 From this spot, position the 12” Hanging Clip.

The top of the hanging clip should be centered

on the spot marked on the wall 6" from the top

of the mirror. Mark the locations for the screw

holes at the bottom of the clip, using the level

to make sure the clip is level and straight.

(Fig.3) Set the clip and level aside.

#5 Using the Drill and 3/16” Drill Bit-Pre Drill the

holes for the wall anchors. Lightly tap the

plastic wall anchors into place with hammer.

#6 Reposition the 12” Clip and secure to the wall

with the screws provided. Check the level again

to determine that the clip is straight and level.

(Fig.4)

#3 From the dot made on the wall, using a

tape rule, measure down 6" and mark

the spot on the wall (Fig.2)

#1 Using a tape measure, check the location where the mirror is to be installed. Be sure the mirror will fit in the desired

location. Approximately 22”W x 28”H is needed for the mirror to fit.

Parts List:

• 22” x 28” Oval Mirror with Mounting Bracket

• 12” Wall Mounting Clip

• 3 Plastic Wall Anchors

• 3 Screws

• 1 Disposable Level

Tools Needed:

Pencil and Eraser, Drill and 3/16” Drill Bit,

Screw Gun or Driver with Phillips Head,

Tape Measure, Hammer and Friend to help.

(Two People are required to mount this mirror).

MOUNTING INSTRUCTIONS FOR MIRRORS

INSTRUCTION #91135

Model #3072 22" x 28" BEVEL OVAL MIRROR

Fig.1

Fig.3

Fig.4

#7 Carefully place the mirror with the mounting plate

onto the installed wall clip. Mirror can be adjusted

side to side by gently sliding the mirror along the clip.

With mirror centered installation is complete - you look marvelous.

Fig.2

Disposable

Level

Style Selections 3072 Installation guide

Brand: Style Selections

Model: 3072

Type: Installation guide

Check the location where the mirror is to be installed. Make sure the mirror will fit in the desired location.
Place the mirror on the wall in the chosen area. Position the mirror at the desired height in the center of the location. Mark a dot or line on the very top edge of the arch.

Download PDF

report

Style Selections 3072 Installation guide

Style Selections 3072 Installation guide

Other documents