SHA-B5Wxx-00 | 009-1649-00 | 180411

Copyright 2018 Savant Systems, LLC

45 Perseverance Way, Hyannis, MA 02601

Savant.com | 508.683.2500

1 of 2

HELPFUL! Before starting the mounting process, review the diagrams below to ensure a trouble free install.

1. Mark on the wall or ceiling where the hanger bolt will be mounted. Ensure the center point of the mount is at least 1

¾ inch from any

obstructions. Savant recommends using a laser level or similar technique to ensure the shade coupler is installed in line with the endpoint

shade mounts.

2. Prepare the wall and install hanger bolt. Leave

½ inch of machine thread exposed.

4. Using a

sleeve. At this point, the shade mount sleeve should easily slide in and out of the hole in the rear of the shade mount. See Horizontal and

Vertical Mount diagrams above for position of the hole in shade mount.

Shade couplers are typically mounted at specific intervals to either distribute the weight of a shade or to separate shades between windows. In

a Savant shade system, a shade coupler should be installed with no more than 8 feet between each mount. As shown in the diagram below, the

two tube end plugs included in the kit slide into the hole in the center of the mount allowing the shades on either side of the mount to operate

independent of each other. In addition, a binding gear is oered for installs where one shade motor, drives more than one shade, separated by

a shade coupler. The SHA-B5Wxx shade coupler can be used with either the floating/outside type shade mounts or with the inside/jamb type

shade mount and is installed using the included shade mount sleeve and 2 inch hanger bolt. Before mounting a shade coupler, both the shade

(Female)

(Female)

Binding

Gear

Horizontal Mount Vertical Mount

(1) Shade Mount - Floating Outside Wide Mount Coupler

(2) Shade Tube End Plug (female)

(1) Shade Binding Gear

(1) 2-inch Hanger Bolt

Customer Community.

– Shade Installation and Wiring Guide (009-1532)

SHA-B5Wxx-00 | 009-1649-00 | 180411

Copyright 2018 Savant Systems, LLC

45 Perseverance Way, Hyannis, MA 02601

Savant.com | 508.683.2500

2 of 2

5. Screw the mounting sleeve onto the hanger bolt until the hex head set screw in the

sleeve is positioned slightly oset from the hole in the shade mount (see diagram).

Leaving the set screw oset will allow the shade mount to be pulled tight to the wall

in the next step.

6. Slide the shade mount over the sleeve until the set screw is visible through hole on

7. Verify shade mount is tight to the wall. If not, turn in the set screw, remove the shade mount, and adjust the mounting sleeve to ensure the

mount is pulled tight to the wall or ceiling.