2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Bercomac
  7. 700623

Bercomac 700623 User manual

  • I've reviewed the instructions for the BERCOMAC Counterweight 2000 SERIES 700623. This document outlines the steps for installation on MTD tractors, detailing how to attach the support plates and secure the weights. I'm ready to answer your questions about the installation process or any of the components mentioned in the guide.
  • What is the first step in the installation?
    How many support plates are used?
    How many weights are included in the set?
Instructions
COUNTERWEIGHT FOR MTD TRACTORS 2000 SERIES
#700623
INSTRUCTIONS
a) Set the parking brake and remove the ignition key.
b) Insert the right support plate (item 1) & left support plate (item 2) on the tractor frame as shown. Secure
each side with the two 1/2’’ x 1’’ hex bolts (item 3) and two flat washers 9/16’’ (item 4). Do not tighten right
now.
c) Slide the support flat bar (item 5) in the vertical slots on the support plates.
d) Place the six weights (item 6) between the support plates and secure in place by inserting the pin (item 7)
through the support plates and through the weights. Lock in place with the a hair pin 4mm (item 8) on each
side.
e) Tighten all bolts and nuts securely.
L-12
POUR ENSEMBLE / FOR KIT
700623
Instructions
CONTREPOIDS POUR TRACTEURS MTD SÉRIE 2000
#700623
INSTRUCTIONS
L-12
POUR ENSEMBLE / FOR KIT
700623
a) Mettre le frein de stationnement et enlever la clé de contact.
b) Insérer la plaque de support droite (item 1) & la plaque de support gauche (item 2) sur le châssis du tracteur
tel qu’illustré. Sécuriser chaque côté avec deux boulons hex 1/2’’ x 1’’ (item 3) et deux rondelles plat
9/16’’ (item 4). Ne pas serrer tout de suite.
c) Glisser la barre plate pour support (item 6) dans les rainures verticales sur les plaques de support.
d) Placer les six poids (item 6) entre les plaques de support et sécuriser en place en insérant la goupille (item
7) au travers des plaques de support et des poids. Bloquer en place avec une goupille à ressort 4mm (item
8) à chaque extrémité.
e) Serrer tout les boulons et écrous fermement.
/