2. SKYDANCE
  3. E1-C

SKYDANCE E1-C User manual

  • Hello! I've analyzed the user manual for the iSkyDance LED Dimmer E1-C. This document details its features as a single channel touch controlled dimmer for LED strips, designed for use in aluminum profiles. It includes information about its installation, technical parameters, and safety certifications. I'm ready to answer any questions you might have about the device based on the manual.
  • What is the maximum output power at 24V?
    What type of LED strip can be connected?
    What is required to be considered during installation in high humidity?
User Manual Ver 1.0.4
Model No.: E1-C
Touch sensor/1 channel constant voltage/3A output/Step-less dimming/Aluminum profile installation
Features
Single Color LED PCBA Mini Touch Dimmer
● 1 channel constant voltage single color LED mini sensor dimmer & switch for aluminum proles.
● High sensitivity touch operation with LED indicator.
● 3A per channel, output connect with 5 meters LED strip, max output power 72W@24V.single color
● 0-100% dimming smoothly without any flash.
● The media on the touch spring can be PC cover, acrylic board or mirror glass.
● 3M paste in the bottom of the PCBA make easy installation and security.
● Low cost and high stability.
● Widely used in table lamps, bedroom lamps, wardrobe lights, etc.
LVD
Technical Parameters
Operation temperature
Environment
Input and Output
Warranty and Protection
5 years
Protection Reverse Polarity
Warranty
Ta: -30
O
C ~ +55
O
C
Output type Constant voltage
Output power Max. 36W@12V
Max. 72W@24V
Output voltage 12-24VDC
Input voltage 12-24VDC
Dimming data
Dimming range
Touch key
0 -100%
Input signal
128Hz
PWM Frequency
Wiring Diagram
+
-
Power Supply
12-24VDC
Constant Voltage
AC100-240V
5m single color LED strip
7.80 mm
50.00 mm
Dimension
E1-C Single Color LED PCBA Mini Touch Dimmer
10.00 mm
Short press on the orange LED: Turn on or off light.
Long press on the orange LED: Dim up, long press again dim down.
PC cover, acrylic board or mirror glass, thickness: 0.5-3mm.
Installation attention
● Put mini sensor dimmer into proles when power is off.
● When install it in high humidity places (for example, bathroom or kitchen), please make sure your LED proles is
isolated against water, otherwise it will affect the sensitivity of touch sensor.
● Pay attention to power input and LED output polarity.
V+
30.00 mm
Touch
spring
Touch
spring
Weight
0.005kg
Gross weight
Net weight
0.011kg
DC input DC output
Safety and EMC
EMC standard (EMC) ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4
Certification CE,EMC,LVD
EN 62368-1:2020+A11:2020
Safety standard(LVD)
/