2. Elsema
  3. FOBswitch
FOBswitch

Elsema FOBswitch User manual

  • Hello! I am an AI chatbot trained to assist you with the Elsema FOBswitch User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • Where can I mount the FOBswitch?
    What is the operating range of the FOBswitch?
    How do I program the FOBswitch to work with my Penta receiver?
    How do I delete receivers from the FOBswitch's memory?
    What is the PentaFOB® Programmer used for?
    What type of battery does the FOBswitch use?
    How do I replace the battery in the FOBswitch?
ELSEMA
4-Button, Wireless Wall Remote with PentaFOB® Technology – FOB Wall Switch
Wireless Wall Remote
4-Button remote control with PentaFOB® Technology
Features
Ultra slim and stylish design for wall mount
Compatible with standard single-gang wall box
or just screw directly on to the wall
Compatible with Penta series receivers
No need to run wires from the wall remote to the light
Easily replace battery without removing from the wall
Designed in Australia with competitive price
Applications
Wireless wall remote for automatic gates and garage doors
Home automation i.e. lights, swimming pool control
…. and anywhere else you need a wireless switch to transmit a
contact closure from a wall remote
Description
The wireless wall remote can be mounted on the standard single-gang electrical wall box or directly on to the
wall. It can wirelessly control lights, automatic gates and garage doors. It transmits a wireless signal to the
Penta receiver which switches relays to turn the device On and Off.
No need to run wires from the wall remote to the lights. Just mount the wall remote on the wall and connect
Penta receiver to the light. Modern design and ultra-thin profile.
Technical Data
Part Number FOBswitch
Supply Voltage CR2032 coil cell battery. Approx. 2 years life with average use
Fre
q
uenc
y
Band 433.100 to 434.700MHz
Operating Temperature Range -5 to 50°C
Decodin
g
S
y
stem Encr
yp
ted 17
b
illion code combinations
Operating Range Operating range of up to 100 metres line of sight
Dimensions 116 mm x 76 mm x 10.6 mm
Weigh
t
70 grams
Useable Receivers All Penta Series
ELSEMA
4-Button, Wireless Wall Remote with PentaFOB® Technology – FOB Wall Switch
Dimensions
FOBswitch Programming Instructions
1. Check that all switches are “OFF” on the receivers 12-way dip switch
2. Press and hold the program button on the receiver
3. Press the remote button for 2 seconds, receiver LED will
flash and then turn Green
4. Release the button on the receiver and the remote
5. Press remote control button to test the receiver output
Deleting Receivers Memory
Short the Code Reset pins on the receiver for 10 seconds. This will delete all the remotes from the receiver’s
memory.
PentaFOB® Programmer
This programmer allows you to add and delete certain remotes from the receiver memory. This is used when a
remote control is lost or a tenant moves from the premises and the owner wants to prevent un-authorised access.
PentaFOB® Backup Chips
This chip is used to backup or restore the contents of a receiver. When there are 100’s of remotes programmed
to a receiver the installer normally backups the receiver memory in case the receiver is damaged.
ELSEMA
4-Button, Wireless Wall Remote with PentaFOB® Technology – FOB Wall Switch
Battery Replacement
When the red LED starts to blink during normal operation, this means that the battery is low and will need
replacing soon.
The FOB wall switch uses a CR2032 battery. Make sure to use the same battery type when replacing. Please
following the instruction below to replace the battery.
/