MD Sports YUS916_067M Operating instructions

Brand: MD Sports

Model: YUS916_067M

Type: Operating instructions

MODEL: YUS916_067M

Menards

ASSEMBLY INSTRUCTIONS

www.themdsports.com

YUS916_067M

(Continued on the next page.)

Phillips Screwdriver - Not Included

Standard (Flat Head Screwdriver) - Not Included

CAUTION!

Electric screwdrivers may be helpful during assembly; however, please set a low torque and use

extreme caution.

1 - This product is intended for INDOOR use only.

TOOLS REQUIRED

ASSEMBLY TIPS

IMPORTANT NOTICE!

WARNING:

Adult Assembly Required.

WARNING:

CHOKING HAZARD 

No Children in

Assembly Area

Keep away from pets

Do not use or keep product

outdoors. For indoor use only.

No wet/humid conditions.

1 - Please read the instructions carefully, and follow all assembly, operation, and safety instructions properly in order to avoid

damage or injury. For the assembly, at least two adults are required.

2 - Some figures or drawings may not look exactly like your product. Please read and understand the text before beginning each

assembly step.

CAUTION!

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to

operate the equipment.

Power Tools

- Set Low Torque

High Torque

over tightened

2 3 41

x1 x2 x2 x2

6 75

x1 x2

Platform

Platform Lock Pole with Hanger Hanger Hook

4X12mm Screw

Electronic Scorer 4X10mm Bolt

YUS916_067M PARTS LIST

www.themdsports.com

YUS916_067M

(Continued on the next page.)

FOR FIG. 1 FOR FIG. 3FOR FIG. 1 FOR FIG. 3

FOR FIG. 5 FOR FIG. 3FOR FIG. 1

Speed Bag

YUS916_067M PRE-INSTALLED PARTS

FOR FIG. 6

ASSEMBLY INSTRUCTIONS:

1. Find a clean, level place to begin the assembly of your product.

2. Remove all the parts from the box and verify that you have all of the listed parts as shown on the parts list pages.

Carefully cut or tear the four corners of the box so that the bottom of the box can be used as your work surface.

X 1

X 2

X 4

www.themdsports.com

YUS916_067M

(Continued on the next page.)

FIG. 1

FIG. 2

BOTTOM VIEW

Note: Open the bottom clip on

the Lock.

Repeat for both Platform Locks.

www.themdsports.com

YUS916_067M

(Continued on the next page.)

X 2

FIG. 3

FIG. 4

Note: Then close the bottom

clip on the Lock.

Note: Slide FIG 3 Assembly through

the Platform Lock on FIG 2 Assembly.

FIG. 3 Assembly

FIG. 2 Assembly

FIG. 6

www.themdsports.com

YUS916_067M

(Continued on the next page.)

SIDE VIEW

Note: Press in the push pins and

insert pole into the Electronic

Scorer.

Press

X 1

FIG. 5

WARNING:

1) Requires 2 “AAA” batteries (not included).

2) Do not mix old and new batteries.

3) Do not mix alkaline, standard (carbon zinc),

or rechargeable (nickel-cadmium) batteries.

BACK VIEW

Battery Installation

Battery Box: Unscrew the bolt using a screwdriver and open the battery box. Insert 2 “AAA” batteries ( not included) in the order

of polarity as shown on the inside cover. Then close the cover using a screwdriver.

Reminding:

a. Batteries must be installed according to the correct polarization (+ and -) required.

b. Please clean the battery contacts and also those of the device prior to battery installation.

c. If the game will not be used for a long period of time, we recommend that the batteries should be removed.

FIG. 7

X 1

www.themdsports.com

YUS916_067M

(Continued on the next page.)

DO NOT OVER INFLATE

INFLATE

Diameter MAX:

8 inch

CAUTION:

• Inflation using an air pump must be performed by an adult.

• Do not use a high pressure pump or a pump for car tire.

• The maximum air pressure for the Inflatable Target is 2.0 kPa.

• Check before each use and at regular intervals.

FIG. 8

www.themdsports.com

YUS916_067M

(Continued on the next page.)

ADJUST THE HEIGHT

Front of the door Back of the door

Note: Open the bottom clip on

both Locks. Then slide the platform

up or down, depending on the

desired height.

Note: Make sure the Suction

Cups on the back of the

Electronic Scorer are up

against the door.

Note: Close the bottom clips

on the Locks.

Note: Buckle the Safety Strap.

Note: Hang the unit on the door.

BACK VIEW

Suction

Cups

ELECTRONIC SCORER OPERATION

How to play？

1. Press “ ” to start the machine, the default display time is 30 seconds.

2. Press “ ” to select game time: 30 seconds or 1 minute.

3. Press “ ” again to start the game. The color of the flashing light is relevant to the times of triggering per second.

A. If it’s one time per second, the light is green.

B. If it’s 2-3 times per second, the light is yellow.

C. If it’s more than 4 times per second, the light is red.

Note: After the game is over, the screen will display the total flashing time of the red light.

4. The language (English and French) can be switched by pressing “ ” and “ ” simultaneously for 2 seconds.

The sound canbe turned off by pressing “ ” for 2 seconds. Press “ ”shortly can go back to initial status.

Note: If there is no operation in 5 minutes, the machine will power off automatically.

www.themdsports.com

YUS916_067M

(The last page)

YOU ARE NOW READY TO PLAY!

WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority

to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with the part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including

interference that may cause undesired operation.

MD Sports YUS916_067M Operating instructions

MD Sports YUS916_067M Operating instructions

MD Sports YUS916_067M Operating instructions

Related papers

Other documents