WWW.ONEFORALL.COM 19
Advanced Features
To delete a learned function:
It is possible to delete all learned functions or only
individual learned functions.
To delete individual learned functions, follow the
steps as outline below.
Press and hold MAGIC until the light blinks
twice (the light will blink once then twice).
Press Programme -, Volume -, Volume -
(the LED will blink twice).
Press the device key in which the function
will be deleted.
Press twice on the learned key which will
be deleted (the LED will blink twice).*
If there is another key which you wish to
delete, repeat steps 2-4.
The original functions of the AUDIO ZAPPER
will now be present.
* To delete a Shifted Learned function, press
MAGIC before you press the learned key to be
deleted (during step 4).
To delete all learned functions across all modes:
Press and hold MAGIC until the light blinks
twice (the light will blink once then twice).
Press Programme -, Volume +, Volume -
(the light will blink four times).
Notes:
- During steps 2-8 (pg 17-18), you have approximately 10
seconds to conduct each step. If there is a gap of more
than 10 seconds between two steps, you will have to
start over at step number 2.
- If you learn a function on a key that already performs a
function, the original AUDIO ZAPPER feature
automatically becomes shifted. You can press MAGIC and
then the key to access it.
- The Learning feature is mode specific. Therefore you can
place one learned feature per mode on the same key.
- The AUDIO ZAPPER can learn approximately 16 functions.
- You can replace a learned function by placing another
learned function on top.
- Learning should not be done in direct sunlight or under
incandescent lights.
- Make sure you are using new batteries before following
the instructions above.
- Upon changing the batteries, your learned functions will
be retained.
1
2
3
4
5
6
1
2