Boss Audio Systems BCAM70 User manual

Brand
Boss Audio Systems
Model
BCAM70
Category
Drive recorders
Type
User manual

This manual is also suitable for

Please read all instructions carefully before using
3M Adhesive x 2
Cable Clip
Car Charger
User Manual
Rear Camera
16GB Micro SD Card
Introduction
What’s in the box?
Thank you for purchasing a Boss Audio Systems product. If you
are not totally satisfied, please give us a call at 805-751-4853
or visit our customer service at bossaudio.com/support.
8. Always use the original car charger and power cable provided. Using
any other power adapter will damage the product.
9. Some vehicles keep supplying power even when turned off. Please
manually turn off the dash cam or pull out the car charger to protect
the product when the car is not on.
10. View footage after a couple power cycles to ensure footage is
captured as preferred (automatically record when powering on,
loop, etc).
Tips
1Clean windshield before mounting.
2. Preview the image before mounting.
(ideally behind the rear view mirror)
3. Make sure there is no glare in the picture before mounting.
4. Do not block the view of the road or impede the deployment of any
airbags in case the event of an accident
5. For best quality make sure the windshield is clean and the lens is
periodically cleaned with a soft damp cloth that will not scratch the lens.
6. Reduce the amount of sky in the picture. Too much sky will darken the
road due to the automatic exposure compensation.
7. Do not adjust controls while driving.
Before You Start
1.Status Indicator
2.Display
3.Rear Camera Port
4.Micro USB Port
5.Mic
6.Up Button / Audio Switch
7.Mode Button
8.OK Button
9.Down Button / Front / Rear
Camera Switch
10.Heat Dissipation Hole
11.Micro SD Card
12.Reset Button
13.Power ON/OFF
14.Lens Knob
15.Lens
Description
a. UP button: short press to lock recording mode.
b. MENU button:
In non-recording mode: short press to enter setup menu; long press
to switch among snapshot mode, playback mode, and recording
mode.
In recording mode: short press to turn on/off video sound.
c. Down button: short press to lock recording mode.
Product Overview
Recording/pause
Open/off Mic
Front/Rear Cam
Tips:
1. Emergency recording: Video will be automatically locked when
colliding
2. Screen Off: The Screen will keep recording unless you remove the
car charger
3. Recording/Pause: When power on, it is recording, short press the
"ok" it will pause, short press "ok" it will start recording again
4. Indicator Definition
a. Slow Flash: recording
b. No Light: power off / in non-recording mode
c. Fast Flash: system is abnormal
Button Definitions
Sensor
Lens
Image sensor
Video resolution
Pixel
Memory card
White balance
Video format
Image fomat
Working temperature
Storage temperature
Input
Material
Dimension
Weight
SONY IMX323
F2.0 aperture, 150° wide angle, 6-layer glasses
Wide dynamic 1/2.9 inch 2.1 million pixel COMS
Full HD (1920*1080P/30fps); VGA
2.4-inch TFT LCD screen
Support up to 32GB Micro SD Card
Automatic sunny/cloudy/incandescent/carbon light
H.264, MOV file
JEPG
-20~+70
-30~+85
5V/1.5A(max)
ABS
96.5*65.5*53mm
97.3g
Specifications
1. Install Dash Cam
Remove the protective sticker from the 3M mount and attach it
to the center of the static sticker
* Please push the bracket to make sure it is securely mounted on
the static sticker.
2. Power Supply
Run the power cable in your car as shown by the dotted line in the
picture. Plug the car charger into the cigarette lighter for the power
supply.
* The cigarette lighter position may vary for different vehicles, so
please use the picture below for reference only.
How to install
1. Adjust Angle
Adjust the camera angle to ensure it is facing the front of the car
when powered on.
2. Recording Screen Overview
Recording standby status
Recording
Loop recording
Exposure compensation
Microphone on/off
Micro SD Card
When the product is powered on, the flashing red icon indicates
that it is in recording mode.
How to Use
3. Emergency recording
The "G-sensor" must be turned on in settings in order to use this
function.
It detects possible accidents or collisions automatically and locks
the video in the "RO" folder.
Due to the complexity of road conditions while driving, you may
not find emergency videos in the "RO" folder. Please check the
normal video folder.
The gravity sensing level can be adjusted as shown below.
4. Snapshot
In recording mode, press the "OK" button to stop and press "Menu"
for 2 seconds to get into snapshot mode. In snapshot mode, press
"OK" to take pictures and save automatically.
Dual Record
5. Viewing Videos & Photos
In recording mode, press the "OK" button to stop. Press and
hold "Menu" twice to get into the playback interface. Press the
"Up" or "Down" button to select playback video files or photos
and press "OK" to playback/pause the selected video file. Press
the "Down" button to return to the preview interface.
6. Settings
“MENU" button “Settings"
In system settings, set up screen off time, system time, Micro SD
Card, etc. The specific settings may vary based on the camera's
system version.
7. HDR
8. WDR
When set to 'ON"the picture taken will be clearer at night .
When set to "ON", the screen will adjust the brightness
automatically.
9. Light Frequency
Please set according to local grid frequency to avoid screen flicker
effectively.
10. Press the "MENU" button twice to switch to the device settings
page.
Video type 8GB 16GB 32GB
1080P/30FPS about 80 mins about 320 mins
720P/30FPS about 130 mins about 260 mins about 520 mins
11. Micro SD Card
This device supports a standard Class 10 and above Micro SD
Card with 8GB to 32GB capacity. After inserting the Micro SD
Card, please format it for better compatibility or there may be a
"read card error or not formatted phenomenon".
Loop Recording: The recorder will record over earlier video records
when the Micro SD card is full. Please backup important videos.
Multiple loops may cause damage or age the Micro SD card. If this
happens please replace the card with a new one.
Please buy a genuine Micro SD card from a legitimate source. We
are not responsible for any video loss or damage due to the use of
an unqualified memory card.
Please format a new Micro SD Card before use for a better user
experience.
Do not insert or extract the Micro SD Card while the power is on.
*Note: the above data is for reference only.
about 160 mins
Storage Usage
Problem Possible Cause & Solution
Installing
Process
High temperature
glue insecure
Paste it in the center
Cannot turn on
Please check power supply
If it connects to power supply properly,
Power On
please restart
Auto Restart Please use original accessories, and try to re-insert car charger
Screen Off Please check power supply, and try to re-insert car charger.
Does not start
recording when
power is on
Please use proper Micro SD Card and format it
before use
Abnormal
temination during
Please format Micro SD Card or replace Micro SD
Card
recording process
Make sure there is no dirt on the front windshield
Poor image quality
of the car, and no blockage on the cam lens.
No sound Please turn on Mic on settings
Running
Process
Video damaged Please use proper Micro SD Card
System time error
Please reset system time in “settings”
No response Press"RESET" to restart dash cam.
Troubleshooting
Rear camera function:
1. Rear detection: When the backup camera is plugged in, the screen
automatically switches to the two-way display and both video frames
will work normally.
2. Display switching between front and rear cameras: press “ ” to switch
to single-screen display during video recording.
3. Video files on PC: the last letter of the front camera is "A" and the last
letter of the rear camera is "B".
4. Video files on machine: File name 001 is for the front camera (also
shows as HFD) and File name 002 is for the rear camera.
Precautions
1. This product is a driving assistance product that cannot ensure driving safety.
2. Some functions of the product may be unable to work properly due to vehicle
conditions, driving style, driving environment or others. This product does not
guarantee to save all videos in all situations. The recorded videos are for
reference only.
3. Please install the product correctly. Do not block driver's view or the airbag.
4. Please take off the protective film on the camera lens upon first use. Please
keep the lens clean.
5. Please keep the product away from strong magnetic fields.
6. Please do not insert or extract the Micro SD Card while the camera is running.
7. This product supports a Class 10 Micro SD Card with 8GB to 32GB capacity.
Please format it before use.
8. The product can detect possible accident and collisions automaticallly and
will save the records. But it cannot guarantee to record all accident images.
Slight collision cannot start the G-sensor, so the image may not be recorded
in a dedicated folder.
9. Please press RESET to restart if the product will not work.
10. The normal operating temperature of the dash camera is -20 to 70
11. Please reset system time when it is not in use for a period of time.
12. Do not violently impact or vibrate the product.
13. Do not dismantle or repair it without authorization.
14. The product is an in-car gadget, so do not use it in a rainy or humid
environment.
15. Do not spray water directly inside the car, avoid contact with chemicals or
cleaning agents, which may damage the product.
16. Please use this product within the scope of the law.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17

Boss Audio Systems BCAM70 User manual

Brand
Boss Audio Systems
Model
BCAM70
Category
Drive recorders
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents