HearthSong Sunshine Metal Climbing Dome Assembly Instructions

Brand
HearthSong
Model
Sunshine Metal Climbing Dome
Type
Assembly Instructions
#730767
For ages 4 and up.
Adult assembly and installation required.
Takes 2 adults 2 hours to install.
Weight capacity: 800 lbs.
For outdoor use only, over soft surfaces.
Sunshine Metal Climbing Dome
Assembly Instructions
Conforms to ASTM F1148 Made in China ©2016 HearthSong
®
Madison, VA 22727. 1-800-533-4397 hearthsong.com
Fully Assem-
730767_SunriseGeoDome.indd 1 12/20/16 2:32 PM
Make sure you have all the necessary parts:
Six-Point
Cap (A) x10
Long Bar (E) x35
Carriage
Bolt x130
Locking
Nut x130
Five-Point
Cap (B) x 6
Four-Point
Cap (C) x10
E
A
D
x6
D
E
E
E
Short Bar (D) x30
The assembly of the climber can best be approached as assembling a series of sections. Start by
putting a section together, then make 4 more sections and connect them all together:
The first step to assembling a section is illustrated above.
Following the color and letter key on page one, attach six colored bars (2 D bars; 4 E bars) to a
six-point cap. Tighten the bolts and nuts just enough to hold the pieces in place; do not tighten
more than that.
Make five six-pointed sections.
Step 1:
x5
730767_SunriseGeoDome.indd 2 12/20/16 2:32 PM
Add a top, bottom, and left side to each
of the five sections, using four bars (2 D
bars and 2 E bars), two five-point caps
(B), and one four-point cap (C).
Step 2:
Step 3:
x3
x3
x3
x2
x2
x2
x2
x3
A
E
D
B
D
C C
E
x5
All 5 hex assemblies
attached to each other.
Hex 1 of 5 Hex 2 of 5
x4
Join the sections by adding two bars
(1 D and 1 E) to the four-point caps (C)
at the bottom of the climber...
... and connect the unconnected bar ends to the caps of the
next section (B), until all five sections have been connected.
to form the circular base of the climber.
730767_SunriseGeoDome.indd 3 12/20/16 2:32 PM
Now assemble the section that will
become the top of the climber, using
five D bars and a five-point cap (B).
Step
Step 5:
x5
x5
D
D
DD
B
D
Bolt the assembled top to the
five-point caps (B) on the top
of the completed base of the
climber. Tighten all the nuts
and bolts until snug.
730767_SunriseGeoDome.indd 4 12/20/16 2:32 PM
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

HearthSong Sunshine Metal Climbing Dome Assembly Instructions

Brand
HearthSong
Model
Sunshine Metal Climbing Dome
Type
Assembly Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents