Ultrak T-2 Operating instructions

Brand: Ultrak

Model: T-2

Type: Operating instructions

•

Single countdown timer

•

Jumbo display with extra large digits

•

Loud alarm when time is up

•

Built in memory

•

100 minute countdown capacity

•

Magnetic back clip and easel stand

ULTRAK T

–

MADE IN CHINA

7 43223 00002 9

TO SET TIMER:

•

Press "MIN", "SEC" buttons to set desired timing period.

•

Pressing the "MIN" or "SEC" buttons for approximately 3 seconds will advance the numeral at a faster rate.

TO START TIMER:

•

Once desired timing period is shown on display, press "START/STOP" button to start timer counting down.

•

Timer will continue counting down until it reaches zero, then the buzzer will sound for 30 seconds or until the

"START/STOP" button is pressed.

TO DISCONTINUE OR RESET TIMER FUNCTION BEFORE THE TIMING PERIOD ENDS:

•

To stop the timer before the timing period ends, press the "START/STOP" button. The time shown can be cleared

by using the "CLEAR" mode (pressing the "MIN" and "SEC" buttons together).

•

The timer can be temporarily stopped by pressing the "START/STOP" button. To restart, press the "START/STOP"

button again.

BUILT-IN MEMORY FUNCTION:

•

The same countdown timing period can be repeated by pressing the "START/STOP" button after the alarm sounds.

•

To set a new timing period, use the "CLEAR" mode (pressing the "MIN" and "SEC" buttons together), and repeat

procedure of "TO SET TIMER" as above.

Note: After battery is inserted, press "CLEAR" (pressing the "MIN" and "SEC" buttons together), to reset before

operating the timer.

INSTRUCTIONS:

T – 2 Timer

CEI ONE YEAR LIMITED WARRANTY

CEI warrants this product (except for batteries) to be free from defects in materials and workmanship under normal

use for one years from the date of purchase. CEI will, at its option, repair or replace the product free of charge.

The warranty does not apply to damage caused by negligence, accident, misuse or repair. No responsibility is

assumed for any incidental or consequential damages. Some states do not allow limitations on how long an

implied warranty lasts and some states do not allow the exclusion or limitation of incidental or consequential

damages, so that the above limitations may not apply. This warranty gives specific legal rights, and other rights

may exist which vary from state to state. To obtain warranty service send the unit prepaid and insured, with dated

proof of purchase, to: CEI, 550 Patrice Place, Unit C, Gardena, CA 90248.

Ultrak T-2 Operating instructions

Ultrak T-2 Operating instructions

Ultrak T-2 Operating instructions

Related papers

Other documents