Scotch 105 User guide

Brand
Scotch
Model
105
Type
User guide
3M and Command are trademarks of 3M.
© 3M 2012. All rights reserved.
A ly Decorative Project:
Window
Decorations
Materials needed:
• 8 sheets of tag board (2 of each
color)
• 1 roll cellophane wrap
• 1 package Mylar wrapping paper
• 1 can 3M Super 77 Spray
Adhesive
• 1 roll colored string (coordinated
to tag board colors)
Steps:
Trace 3” circles onto each
sheet of tag board. Trace
a slightly smaller diameter
circle inside of each to
create a donut outline.
Cut out each circle of tag
board and the inner circles.
You will have 18 disks of
each color and 18 donuts in
each color.
Add some of your personality
to your windows!
Using the tag board disk
as your guide, trace and
cut 18 disks of cellophane
wrap and 18 disks of Mylar
paper. Be sure to allow an
extra ¼” diameter in these
disks so they will overlap
the inner space of your
tag board donuts.
Cut 30, 9” lengths of string.
• 1 can high gloss spray
paint (optional)
• 1 pair Scotch™
Precision Ultra Edge
Non-stick Scissors
• Pencil and circular
objects for tracing
• Ruler
• Scotch® Magic™ Tape
• 6 Command™ Clear
Small Hook
Project steps continued -->
3M and Command are trademarks of 3M.
© 3M 2012. All rights reserved.
A ly Decorative Project:
Steps (continued):
Repeat step 7, linking each tag
board unit to another using the
lengths of string. Assemble 5 tag
board units per strand. You should
end with 6 strands, with some
extra left over. Be sure to alternate
Mylar and cellophane wrap and
alternate tag board colors to
create a pleasing pattern.
Use Scotch® Magic™
Tape to attach the
tag board disks to the
center of each length
of string between
every two units.
Use Scotch® Magic™
Tape to attach the nal 6
pieces of string in loops
to the top tag board unit
on each strand.
Ax 6 Command™ Clear
Small Hooks (following all
package instructions) to
tops of window frames.
Hang each strand on the
hooks. Enjoy!
In a well-ventilated,
masked o area, spray
one side of a tag board
donut. Move the donut
to a clean sheet of
paper and center the
Mylar disk over the
donut. Place and press
to secure the bond.
Place the tip of a
length of string onto
the edge of the
adhesive-sprayed
donut.
Center a second
tag board donut on
top of the prepared
string/Mylar/tag
board unit and press
to secure the bond.
  • Page 1 1
  • Page 2 2

Scotch 105 User guide

Brand
Scotch
Model
105
Type
User guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents