Belle Foret APBNVT3722 Installation guide

Type
Installation guide
hts reserved.
FOR MODEL: APBNVT3722
TOOLS REQUIRED
Please read and understand all safety precauons and instrucons in this manual before you begin the installaon of this product.
NOTE
Observe local plumbing and building codes.
PLANNING INSTALLATION
Before beginning installaon of this product, ensure all parts are present. Compare all parts with the Hardware Included
and Package Contents secons of this manual. If any part is missing or damaged, do not aempt to assemble, install, or
operate the product. Contact customer service for replacement parts at 1-800-880-8164.
Esmated Installaon Time: 15 minutes
Contact Belle Forêt at (800) 880-8164. Copyright ©2015, World Imports Decorave Plumbing. All rights reserved.
PAGE 1
APPLEBY VANITY COMBO
INSTALLATION INSTRUCTIONS
PART DESCRIPTION QUANTITY
A Vanity 1
B 1
A
Backsplash
Silicone
sealant
Clean
rag
B
TOOLS REQUIRED
PACKAGE CONTENTS
CARE & CLEANING
To protect your bath furniture, we suggest the following:
Avoid placing your furniture in direct sunlight, as sunlight causes fading.
Clean up spills immediately. Use a blong rather than a wiping acon. Water le over a long period of me will cause white
spots in the finish.
Alcohol, perfume, aer-shave and medicaons can cause severe finish damage.
For best results in cleaning and polishing your bath furniture, we recommend the following:
Dust frequently with a clean, so, dry, lint-free cloth. Clean the surface by rubbing in the direcon of the grain.
Polish your furniture approximately every six months with a product that contains detergents, emulsifiers and mineral oil.
The detergents clean dirt from the furniture; the emulsifiers give it body to clean and last longer; the mineral oil is le behind
as a barrier for dirt and moisture that can harm the finish. There is no grit to harm the finish, no wax build-up, and no silicone
to raise the sheen and act as a barrier for touch-ups and refinishing.
Clean the outside surface with mild soap, warm water, and a so cloth.
On stubborn stains, use a powdered detergent and damp sponge or nylon scouring pad.
Never use abrasive scouring powders, cleansers, or pads because they will scratch, damage, and dull the surface.
Contact Belle Forêt at (800) 880-8164. Copyright ©2015, World Imports Decorave Plumbing. All rights reserved.
PAGE 2
APPLEBY VANITY COMBO
PRE-INSTALLATION
hts reserved.
2: INSTALLING THE BACKSPLASH
1.
2.
3.
4.
If the floor is uneven, causing the vanity (A) to wobble, determine which
foot needs to be adjusted in height.
Carefully lt the vanity (A) either backwards or forwards to access the leg
leveler. Turn the leveler clockwise to make the leg longer, or
counterclockwise to make it shorter.
Repeat as needed with the other feet unl the vanity stands solidly on the
floor.
1: ADJUSTING THE LEG LEVELERS
1.
2.
3.
CAUTION
Two people are needed to safely lt the vanity and access the leg levelers.
3: REMOVING THE DRAWER
1.
2.
3.
Fully extend the drawer.
Pull the two latches outward on the underside of the drawer to release
the lock.
Simultaneously lt and li the drawer upwards to pull it out of the
vanity (A).
Wipe off the area of the top (A) where the backsplash (B) will sit using
a clean rag.
Apply a line of silicone onto the top (A) along the back edge.
Align the backsplash (B) with the back edge. Slowly lower it onto the
top (A) and gently press to adhere.
Wipe away any seeping silicone from underneath the backsplash (B)
with a clean rag.
B
A
OPTIONAL
OPTIONAL
A
Contact Belle Forêt at (800) 880-8164. Copyright ©2015, World Imports Decorave Plumbing. All rights reserved.
PAGE 3
APPLEBY VANITY COMBO
INSTALLATION INSTRUCTIONS
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Belle Foret APBNVT3722 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages