Belle Foret APBNM2431 Operating instructions

Brand: Belle Foret

Model: APBNM2431

Type: Operating instructions

hts reserved.

FOR MODEL: APBNM2431

TOOLS REQUIRED

Please read and understand all safety precauons and instrucons in this manual before you begin the installaon of this product.

NOTE

Observe local plumbing and building codes.

PLANNING INSTALLATION

Before beginning installaon of this product, ensure all parts are present. Compare all parts with the Hardware Included

and Package Contents secons of this manual. If any part is missing or damaged, do not aempt to assemble, install, or

operate the product. Contact customer service for replacement parts at 1-800-880-8164.

Esmated Installaon Time: 15 minutes

PAGE 1

APPLEBY MIRROR

INSTALLATION INSTRUCTIONS

TOOLS REQUIRED

PACKAGE CONTENTS

CARE & CLEANING

To protect your bath furniture, we suggest the following:

□ Avoid placing your furniture in direct sunlight, as sunlight causes fading.

Clean up spills immediately. Use a blong rather than a wiping acon. Water le over a long period of me will cause white

spots in the ﬁnish.

Alcohol, perfume, aer-shave and medicaons can cause severe ﬁnish damage.

□

For best results in cleaning and polishing your bath furniture, we recommend the following:

□

Dust frequently with a clean, so, dry, lint-free cloth. Clean the surface by rubbing in the direcon of the grain.

Polish your furniture approximately every six months with a product that contains detergents, emulsiﬁers and mineral oil.

The detergents clean dirt from the furniture; the emulsiﬁers give it body to clean and last longer; the mineral oil is le behind

as a barrier for dirt and moisture that can harm the ﬁnish. There is no grit to harm the ﬁnish, no wax build-up, and no silicone

to raise the sheen and act as a barrier for touch-ups and reﬁnishing.

Clean the outside surface with mild soap, warm water, and a so cloth.

On stubborn stains, use a powdered detergent and damp sponge or nylon scouring pad.

Never use abrasive scouring powders, cleansers, or pads because they will scratch, damage, and dull the surface.

□

PAGE 2

APPLEBY MIRROR

PRE-INSTALLATION

PART DESCRIPTION QUANTITY

A Mirror 1

B 2

C 2

Anchor

Screw

Phillips

screwdriver

Carpenter’s

level

Tape

measure

Claw

hammer

Pencil

hts reserved.

PAGE 3

INSTALLATION INSTRUCTIONS

1: PREPARING THE WALL

2: HANGING THE MIRROR

Place the mirror (A) against the wall and determine your desired hanging

locaon. Using a pencil, mark two locaons on the wall that match up with

the mirror’s (A) pre-aached mounng hooks.

Ensure the marks are horizontally straight by using a level.

Use a hammer to gently punch the anchor (B) halfway into the wall at each

marked locaon. Finish screwing in the anchor (B) with the screwdriver.

Using the screwdriver, insert the screws (C) into the anchors (B), leaving

approximately 1/8 in. of the screw revealed.

Hold the mirror (A) in place against the wall and line up the mounng hooks

with the screws (C).

Loop the mounng hooks over the scews (C) to hang the mirror (A).

APPLEBY MIRROR

Page is loading ...

Belle Foret APBNM2431 Operating instructions

Brand: Belle Foret

Model: APBNM2431

Type: Operating instructions

Download PDF

report

in other languages

español: Belle Foret APBNM2431 Instrucciones de operación

Belle Foret APBNM2431 Operating instructions

Belle Foret APBNM2431 Operating instructions

in other languages

Related papers

Other documents