CMA Dishmachines CMA-180-VL-FL Quick Installation Guide

CMA Dishmachines
Brand
CMA Dishmachines
Model
CMA-180-VL-FL
Category
Dishwashers
Type
Quick Installation Guide

This manual is also suitable for

1
STEP
WALL
DRAIN
8"
FLOOR DRAIN
Connect a 2" drain pipe (not supplied) from scrap
accumulator to floor or wall drain.
3 Phase: Connect power supply wires, L1, L2 and L3
to the appropriate terminals marked L1, L2 and L3 on
the power block. Important: If one of the three wires
has higher voltage it must be inserted as L-2.
4
STEP
L2
L3
L1
208/240
3 PHASE OR SINGLE
PHASE
L1 AND L3
FOR SINGLE PHASE
11-2016
CMA-180VL-FL
REAR VIEW
WARNING: Electrical and
plumbing connections need
to be made by a licensed
service person and comply
with all Federal, State and
Local Health, Electrical,
Plumbing and Safety codes.
CMA-180VL-FL
Quick Setup
Instructions
DRAIN
CONNECTION
1
DETERGENT
FITTING INLET
5
HOT WATER
INLET
2
MIXING
CHAMBER
6
POWER
BLOCK
4
COLD WATER INLET
LOCATED ON FRONT
OF MACHINE
3
PN: 10130.17
Connect cold water inlet (min 41°F and max 65°F).
(Review other side for details).
3
STEP
COLD WATER INLET
2
STEP
Connect dishmachine to hot water source 120°F -
140°F.
HOT WATER INLET
Remove the plastic plug to install the detergent
fitting (provided by your dispenser supplier;
CMA does not supply).
5
STEP
PLASTIC
PLUG
Remove the plug from the mixing chamber and install
the rinse injection fitting (rinse injection fitting
provided by your dispenser supplier; CMA does not
supply).
6
STEP
RINSE
START
Remove the stainless steel plug to install the detergent
probe (provided by your dispenser supplier; CMA
does not supply).
13
STEP
11-2016
CMA-180VL-FL
Quick Setup Instructions
CMA-180VL-FL
FRONT VIEW
AUTO FILL
RINSE / START
MIXING
CHAMBER
POWER
ON OFF
7
DOOR
HANDLE
11
HEATER
THERMOSTAT
12
GAUGES
9
BOOSTER
HEATER
DETERGENT
PROBE INLET
13
WASH TANK
HEATER
COLD WATER
INLET
BLACK/YELLOW
STRIPED WIRE
BOOSTER HEATER
DAMAGE PREVENTION
CAUTION: TO PREVENT BOOSTER
HEATER ELEMENT DAMAGE, CMA
HAS DISCONNECTED A WIRE FROM
THE “HIGH-LIMIT SWITCH”.
THE BOOSTER TANK MUST BE
FILLED WITH WATER PRIOR TO
CONNECTING THE “REMOVED”
WIRE, AT THE INITIAL FILLING OF
A NEWLY INSTALLED DISHMACHINE.
TO FILL THE BOOSTER TANK, LOCATE
THE “RINSE TOGGLE SWITCH” ON
BACK OF CONTROL BOX. PUSH THE
TOGGLE SWITCH TO ACTIVATE THE
WATER SOLENOID THAT FILLS THE
BOOSTER TANK. THE BOOSTER TANK
INDICATES FULL, WHEN YOU CAN
OBSERVE WATER SPRAYING FROM
THE RINSE ARMS. AT THIS POINT,
AND ONLY AT THIS POINT, SHOULD
YOU CONNECT THE “DISCONNECTED”
WIRE. FAILING TO FOLLOW THESE
IMPORTANT INSTRUCTIONS WILL
DESTROY THE HEATING ELEMENT,
BECAUSE THE ELEMENT SHOULD
ONLY OPERATE WHEN FULLY
SUBMERGED IN WATER.
NOTE: The wash-down feature for HR
Condenser is automatically activated when
the machine’s “Master Power Switch” is
turned “off”. Approximately (2) gallons of
hot water will spray over the HR Condenser,
cleansing and discharging into drain system.
Press "AUTO FILL" immediately after power is
turned on. Timer will automatically fill until the water
overflows into the scrap trap. The initial fill may need
to be pushed twice to fill wash tank.
11
STEP
RINSE
START
Press “RINSE/START ROCKER SWITCH” to start.
10
STEP
RINSE
START
Press "RINSE/START ROCKER SWITCH” to fill the
booster tank.
8
STEP
RINSE
START
Press "POWER ON/OFF" rocker switch to turn on
dishmachine.
7
STEP
RINSE
START
8
6
3
RINSE / START
10
WARNING: Electrical and
plumbing connections need
to be made by a licensed
service person and comply
with all Federal, State and
Local Health, Electrical,
Plumbing and Safety codes.
Adjust the temperature by removing the panel in front
of the respective heater and turning the adjustment
post. Wash temp. 155°F. Rinse temp.180°F.
STEP
12
The Spirit of Excellence
an Ali Group Company
9
STEP
20
Adjust pressure regulator located next to cold water inlet,
to 20 psi (maximum).
RINSE
PRESSURE
PRESSURE
RELIEF VALVE
  • Page 1 1
  • Page 2 2

CMA Dishmachines CMA-180-VL-FL Quick Installation Guide

CMA Dishmachines
Brand
CMA Dishmachines
Model
CMA-180-VL-FL
Category
Dishwashers
Type
Quick Installation Guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents