Minka-Lavery 422-77-L User manual

Type
User manual
INSTALLATION INSTRUCTIONS
FOR 422-L 423-L 424-L
For LED Wall Mount Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT!COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEUR
MOUNTING THE FIXTURE (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box. If necessary
remove the existing fixture and its mounting hardware.
2. Carefully remove the new fixture from the carton and check that all
parts are included as shown in the illustration.
3. Position mounting plate (D) on the wall, and mark the location of
the two drywall anchors (A). Pre-drill the holes for the drywall
anchors (A) and insert the drywall anchors (A) into the wall.
4. Attach the mounting plate (D) to the junction box using junction box
screws (C) (Size: 8-32*1/2’’L). The side of the mounting plate
marked “GND” must face out.
5. Place the wood screws (E) through the holes of the mounting plate
(D) and into the drywall anchors (A) to secure the mounting plate
(D) to the wall.
CONNECTION THE WIRES (Fig. 2)
6. At this point, connect the electrical wires as shown in Fig.2, making
sure that all wire connectors are secured. If your outlet has a
ground wire (green or bare copper), connect the fixture's ground
Wire to it. Otherwise, connect the fixture's ground wire directly to
the mounting plate using the green screw provided. After the wires
are connected, tuck them carefully into the junction box.
FINISHING THE INSTALLATION (Fig. 1)
7. Align back plate (G) to mounting plate (D) and secure with screws
(B).
8. Place glass shade (I) inside the Frame (H).
Your installation is now complete. Return power to the junction box and
test the fixture.
CAUTION /ATTENTION:
When handling the fixture, do not apply
pressure to the LEDs. Hold the fixture by the base or fixture body (G)
only.
Fig.1
Fig.2
Replacing LED module (Fig.3)
The LED module can be replaced by a qualified electrician without
cutting the wires and without damaging the decorative element to which
the fixture is attached. See installation steps for more details (Fig 3.)
Warning: Turn off power at the fuse box or circuit
breaker before replacing LED module.
a. To remove the fixture from the wall: Remove the glass(I),loosen
screws (B) and remove the wire connectors. Then place the fixture
on a clear flat surface.
b. Loosen screw(M) to remove the glass shade (L)
c. Loosen screws (K), rubber washers (J), then carefully remove LED
module (I).
d. Reverse steps a-c for installing the new LED module.
Note: The LED module should be provided by a specified
supplier.
IMPORTANT:
Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with C-L (CFL & LED) type and Incandescent/Halogen type
dimmers
Fig.3
II 814
423-L
424
-
L
  • Page 1 1

Minka-Lavery 422-77-L User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI