Halcyon EX383 UPS Underwater LED Spot User manual

Hello! I've reviewed the datasheet for the HALCYON EX383 UPS Underwater LED Spot. This document provides details on the installation, features, and specifications of this underwater lighting device, including its temperature range, depth limitations, and electrical requirements. I'm ready to answer any questions you might have about the product.
What is the maximum installation depth?

What is the required input voltage?

What material is the housing made of?

Can this device operate above water?

Can the device be used in saltwater?

Front ring Reflector 3Housing

Bracket

OUTLINE DIMENSION BOM

1.FEATURES

EX383 UPS

Underwater LED Spot

Note: Please use the diagram as a guide only. If there is a discrepancy between the actual product

and drawing, please refer to the actual product.

• Applicable environment temperature: -20°C... +40°C

• Do not install in depths greater than 1m

• Do not install above water line, operation above water will cause overheating and failure.

• Input voltage 24VDC. When installing the product please check the data label on the product and

cable. Total demand of power is according to total power consumption +total power of cable

impedance consumption. All installation work must be carried out by a registered electrician.

• 316 Stainless Steel, do not install this product in saltwater or in the environment which is high salt

or high acid.

2.WIRING DIAGRAM

2.1: Low voltage single colour fitting: use external power supply, the input voltage of power supply

must be consistent with the requested input voltage of the fitting, as the fitting is constant voltage

input type. The power consumption of power supply must be decided by installer according to the

requirements from the site.

Item No.

EX383 UPS 1×20W 24VDCR19 22 1478241000

Reflector Degree (°)

3.2: Electrical parameters

3.SPECIFICATIONS

H07RN-F 2

1.0mm L=3m(for single color)Power cable:

Housing: Molding shaped stainless steel 316L#

Front cover: Molding shaped stainless steel 316#

Reflector: Optical lens, efficiency≥85%

PCB: Excellent heat conductivity aluminum.coefficient of heat

Conductivity≥2.0w/mk

PMMA: 8mm

Gasket: Silicone Gasket

Driver: Constant current output

Single color LED=1-circuit output

3.1 Material specification.

Light source Input Voltage Typical operating

current (mA) Typical Consumption (w) Typical luminance (lm)

Example of wiring:

24VDC: Circuit of product