2. SALICE
  3. Universal B 3/8 lipp

SALICE Universal B 3/8 lipp Operating instructions

  • Hello! I am a chat assistant and I have analyzed the provided document about the Salice Lipped Face Frame Hinge. I understand it provides instructions on mounting, adjusting, and the soft-close mechanism. I am ready to answer your questions about this product.
  • How do I decide how many hinges I need?
    What size hole do I need to bore for the hinge cup?
    How do I adjust the door position?
Woodcraft, 406 Airport Industrial Park, P.O. Box 1686, Parkersburg, WV 26102-1686
© 2020 by Woodcraft Supply, LLC. “Helping You Make Wood Work” is a registered trademark of Woodcraft Supply, LLC.
77E46
Hinge Mounting Instructions
A. Decide on the number of hinges you want to use and mark their
centerline locations on the back of the door (see Figure 1).
B. Transfer the centerline to the inside of the cabinet.
C. Using a 35mm (13⁄8") forstner bit bore the mounting hole for the
hinge cup in the back of the door to a depth of 9mm. To insure the
proper operation of the installation we suggest that you make a
sample and test the fit before actually boring the finished stock.
D. Locate the screw hole centerlines for the mounting clip 46mm
from the front edge of the cabinet. Align the center of the mounting
plate with the hinge centerline previously marked on the inside of the
cabinet and install screws.
E. With the hinges in the open position simply “clip” the arm to the
mounting plate and follow the diagram for “three-way” adjustment!
See page 2.
Number of Hinges per Door
There is no general rule. Obviously this depends on the size and
weight of the door. We can give you a rough guide for the more stan-
dard applications. In special cases (a door with a mirror) we suggest
you conduct a trial for yourself.
09/22/20
Product #174903
Salice 3⁄8" Lipped Face Frame
Hinge Application
1
Fig. 1
46
32
Woodcraft, 406 Airport Industrial Park, P.O. Box 1686, Parkersburg, WV 26102-1686
© 2020 by Woodcraft Supply, LLC. “Helping You Make Wood Work” is a registered trademark of Woodcraft Supply, LLC.
77E46
09/22/20
2
Traditional Depth
Adjustment
The screw on the back end of the
mounting bracket can be turned to
adjust the door from front to back.
Remove the Smove from the hinge arm.
Insert the Smove frontally.
Sideways Adjustment
The screw at the front of the hinge arm can be turned in or out to
adjust the door alignment left or right.
Height Adjustment
The vertical door alignment can be adjusted by turning the screw
in the center of the mounting bracket. You may need to loosen the
bracket mounting screws. Once the adjustment is made, retighten
the bracket mounting screws.
Uninstalling And Installing The Smove Mechanism
The hinges come with the Smove soft close mechanism installed. This mechanism may be removed if a self-closing action is desired. You may
also decide to remove the Smove if the door closes too slowly.
Loosen Tighten
/