Page is loading ...
Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at
1 800 282 9346, ext #20
(Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Post Cap (6)
2. Short Rail (12)
3. Post (6)
4.
Long Rail (16)
5. 4” Stainless Steel Screws (64)
General Information
• Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
• We recommend an area approx 4’x 8’ for unobstructed assembling.
• You should not need to use excessive force when assembling components.
10’ Pergola Garden Bed
Please read through before starting assembly.
ASSEMBLY INSTRUCTIONS
1
Ver 1.0/NOV 2013
www.newenglandarbors.com
1
2
3
4
5
Not to Scale
STEP O N E
2
10’ Pergola Garden Bed
Assemble the Long Wall
Take two posts and slide four long rails between the two openings
as shown.
Using the screws provided, fasten the rails to the posts.
Fasten another section of post and four long rails as shown.
Repeat steps one through three for a second long wall.
1
2
3
1
2
STEP T W O
Assemble the Garden Bed
Slide 12 short rails between the two pre-assembled sections from
the previous step as shown.
1
www.newenglandarbors.com
3
4
x2
STEP T W O
Fasten the 12 short boards with the screws provided (32 total).
Pressure fit the post cap into place as shown.
2
3
www.newenglandarbors.com
3
3
www.newenglandarbors.com
3605 32nd St., Building 3, Port Huron MI USA 48060
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
2
Note: The 10’ Pergola Garden Bed is
designed to fit between the two
posts of the 10’x10’ pergola
(sold separately) as shown.
/