ROOF BAG / TRUCK BAG FOR
ALL CARS , SUVS , TRUCKS
ROOF BAG / TRUCK BAG FOR
ALL CARS , SUVS , TRUCKS
PART 01: Installation Steps for Roof Bag
PART 02: Installation Steps for Truck Bag
PART 03: Warm Tips
PART 04: Resetting Password for Bonus Lock
CONTACT US
Thanks for your support on LED Kingdom rooftop bag.
Please read the instructions carefully before use, and keep it for reference in future!
: 888-717-8084
1. The straps end with Velcro. Fold the straps’ ends upwards and attach them neatly with the Velcro to
prevent noises during driving.
2. You can load your bag first, then lift it onto the roof, or put it on the roof first, then load it. The straps have
been designed to withstand emergency stops with 130KG loads, however WE RECOMMEND THAT
YOU LIMIT THE WEIGHT LOAD TO 60-90KG depending on your vehicle and place heavier items
towards the sides of your roof.
3. For maximum safety, we recommend that you check periodically that the LEDKINGDOMUS straps are
still tight.
Installation Steps for Roof Bag
a. Clean the roof of your vehicle.
b. Put the Anti-slip Mat in the top of your vehicle.
c. Place the empty bag on the Anti-slip Mat, so the
zipper is at the back.
d. After filling the bag zip up the double-ended zipper
and secure it with the safety pin provided or with a
lock.
e. Pass the 4 main holding straps through your car
rails. For cars without car rack - through the 4
loops(hooks). Click the top buckle shut.
f. Then tighten the main holding straps in the following
order: the front straps, right and left and then the
rear straps, right and left.
g. Click shut the buckles for the 6 short tightening
straps ( 2 at the front, 2 at the rear, 1 in the middle
of each side) and tighten them well.
a. Gently peel back the door frame rubber seal.
b. Attach the grip hook directly onto the door frame.
c. Pull the looped strap upward.
d. Replace the rubber seal against the door frame and
follow the instructions on the left page.
CAR WITH RACK
CAR WITHOUT RACK
Instructions:
Instructions:
Attaching the grip hooks is super easy!
Attaching the grip hooks is super easy!
NOTE:
Installation Steps for Truck Bed
Truck Bag Setup Instructions
Truck Bag Setup Instructions
Hook & Strap Setup: Step-By-Step
Hook & Strap Setup: Step-By-Step
1.Too much tension WILL POSSIBLY TEAR OFF THE CORNER RINGS - this is NOT COVERED by the
manufacturer warranty! Do not set your adjustable straps with too much cord tension, tension is up to user
so it cannot be covered.
2.MAKE SURE that the bag sits comfortably ON THE BED OF THE TRUCK to ease tension on corner rings.
3. DO NOT GET INSIDE BAG, OR ENCLOSE BAG. Air can be limited inside of enclosed bag space.
VERY IMPORTANT Information before Installation:
Roll bag out fully, laying flat
with the side of 4 corner rings
facing up.
Loosely connect adjustable
bungee straps to truck bed, and
top 4 corner rings(there are 8
total rings, but only 4 are needed
to setup the bag).
Load bag with cargo, luggage,
etc... Once bag is loaded close
main zipper and adjust straps
TO USER PREFERENCE.
Connect strap hooks to bag corner and to
truck bed. Slide hook end through bag corner.
Pull hook up through the bag’s corner ring
and loop cord into the small back hook.
Loop larger hook around cord as shown above.
Cord strap should stay in place, but still loose as
to not place too much tension on rings.
Proceed the same way for all 4 corner rings. All
straps should be secure, but not too tight as to
place too much tension on bag’s corners.
STEP1
STEP3 STEP4
STEP2
Resetting Password for Bonus Lock
Warm Tips:
For better using LED Kingdom car rooftop bag
For better using LED Kingdom car rooftop bag
Others
Others
How to reset password ?
How to reset password ?
Inspect for signs of wear and damage before each use. do not use if worn or damaged.
Fill it as full as possible to avoid fabric damage caused by wind flapping and to avoid water entry through
the zipper
Cushion hard or sharp objects inside carrier to avoid denting the roof
Zipper must be fully closed, zipper slider reach at the back of the carrier, zipper flap pointing down to
prevent water entry from zipper
Loose fabric creases cause noise, lower gas mileage and damage the fabric.Hold down loose creases
with straps. Use extra straps if necessary.
Be aware of the width and height of your cargo since low clearance branches, bridges, and parking
garages can affect the load.
Do NOT exceed the vehicle manufacture’s rated roof capacity. failure to comply with this regulation will
result in damage to the vehicle and is exceedingly dangerous during transit.
Do NOT exceed the speed limit while driving with cargo bag installed on the roof of the vehicle. if you
hear any flapping noises while driving pull over immediately and double check installation.
Avoid long-term storage in direct sunlight to avoid color fading and prolonged UV damage.
Do not leave an empty cargo bag mounted to the vehicle. once cargo is fully unloaded remove the cargo
bag from the roof.
NOTE: The initial password is 0000
1. Adjust the password to the initial password 0-0-0-0
and align the password line.
2. Lift the lock hook, turn it 90 degrees counterclock
wise, press the lock hook firmly and dial the code
wheel to select the four-digit number password you
need, and align the numbers towards two small
triangles on each side.
3. Lift the lock hook back, lock it normally, dial the
password, and the new password is set successfully.
Lock hook
Password dial
Password line
/
