The Shopping mode shuts off
automatically after approximately 6
hours.
The function switches off by
selecting a different fridge
set temperature.
1. To switch on the function do one of
the following:
• Press Shopping mode.
• Press Mode until the
corresponding icon appears.
The Shopping mode indicator appears.
2. To switch off the function before its
automatic end do one of the
following:
• Press Shopping mode.
• Press Mode in order to select an
other function or until you can see
none of the special icons.
The Shopping mode indicator goes off.
3.11 Door open alarm
An acoustic alarm will sound if the door is
left open for a few minutes. The door
open alarm conditions are indicated by:
• flashing Alarm light
• acoustic buzzer
When normal conditions are restored
(door closed), the alarm will stop.
During the alarm, the buzzer can be
switched off by pressing alarm button.
3.12 Selecting and dispensing
water
Before dispensing water, select either
still cold water, low sparkling water or
high sparkling water.
The actual choice is indicated by the
indicator.
1. Water is dispensed by pressing a
glass or other container towards the
flap.
2. Draw back the glass or container to
stop the water flow and the indicator
goes off after a few seconds.
Any water that drips or is spilled is
collected in the drip tray below the
water dispenser. The drip tray can be
detached and emptied when
necessary.
3.13 Lighting
The water dispenser lighting illuminates
automatically when water is dispensed.
3.14 For continuous lighting
Press the light button and the lighting
goes on.
Brightness is now about 20% until the
dispenser is used.
3.15 Switch off the lighting
Press the light button and the lighting
goes out.
3.16 Water filter indicator
1. When the water filter indicator lights
up the water filter has about 20%
remaining lifetime.
In this situation, it is recommended
that you buy a replacement filter.
2. When the water filter indicator starts
flashing, the water filter lifetime is
consumed . Replace the water filter
without delay, refer to "Installation of
the water filter".
3. When the water filter is replaced.
a. Press the filter reset button for 3
seconds to reset the water filter
indicator.
3.17 Water circuit cleaning
1. If you need to clean the water system
press Mode until the corresponding
icon appears.
After a few seconds the still cold water
indicator goes on.
Water select locked into still cold water.
2. Dispensing water in total 2 minutes.
The water system is cleaned.
The water circuit cleaning and the still
cold water indicator goes off.
3. To switch off the function before its
automatic end press Mode until the
corresponding icon appears.
After a few seconds the water circuit
cleaning and the still cold water indicator
goes off.
ENGLISH 29