Page is loading ...
YARM24 INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
YARM24
The YardBlaster Mounting Arm is used to attach the YardBlast-
er lighting xture to a wall or pole. YardBlaster must be wired in
accordance with the National Electrical Code and applicable
local codes. Proper grounding is required for safety.
1.
Assemble the mounting clamp. Insert 4 self
tapping screws. To hold the arm clamp together
use bolts and nuts provided.
2.
Use bracket to attach YardBlaster to mounting
arm. Secure with 2 bolts supplied.
3.
Bolt mounting arm assembly to pole or other
structurally sturdy surface.
Easy Installation & Product Help
24” YardBlaster Mounting Arm
INSTALLATION INSTRUCTIONS
The YardBlaster is for outdoor use and should not be
used in areas with limited ventilation of high ambient
temperatures. Installation should be done by a qualied
electrician.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE
LOCATION
Select a location on a structurally sound, at wall or
pole 10-25 feet from ground. Fixture should be located
on wall or pole at least 18” below any overhang or other
structural detail.
Fixture should not be recessed. Fixture must be po-
sitioned with lamp in verticle position with lampholder
base up.
MOUNTING
YARM24 MOUNTING
1. Secure the Interlocking Mounting Clamps around the
YARM24 using the provided truss screws, locknuts and
hex-nuts.
2. Mount the YARM24 to a sturdy wall. Using the mounting
template on the YARM24 mounting plate as a guide,
mark the 4 mounting holes. Drill 3/16” pilot holes and
use provided Lag Bolts (4) to mount to wooden surface
or use appropriate mounting hardware (not supplied)
suitable for the mounting surface.
3. Secure the YARM24 in the Housing Arm by following
installation directions on xture instruction sheet.
4. Follow wiring directions on xture installation instruction
sheet to complete electrical splices.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture.
LOCATION
Select a location on a structurally sound, at wall or pole. Fixture should be located on wall or pole at least 18” below any overhang
or other structural detail. Fixture must not be recessed.
SCALE 0.750
SCALE 0.750
Lag Bolts (4)
YARM24
Housing Arm
Interlocking Mounting
Clamps
YARM24-IN-1213
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2013 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
email
Answered promptly sales@rabweb.com
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation,
operation or maintenance.
YBLED26
(Available upon request)
/
