2. Big Lots
  3. DS-56989
DS-56989

Big Lots DS-56989 User manual

  • Hello! I've reviewed the user manual for the '2 tier stand' by real living. This document includes a detailed parts list, assembly guide, and care instructions. I'm ready to answer questions you may have about setting up or using your new stand.
  • What should I do when unpacking the stand?
    How should I clean the stand?
    Where should I place the 2 tier stand?
Item# DS-56989
SKU# 000000000
Parts List....................................... Page 2
Assembly Instructions................. Page 3
Safety & Care Instructions........... Page 3
2 TIER STAND
USE AND CARE INSTRUCTION
We have designed our 2 tier stand with you, the customer in
mind. Our clear, easy to follow, step by step instructions will
guide you through the project from start to finish.
Feel confident that this will be a fun and rewarding project.
The final product will be a quality piece of 2 tier stand that
will go together smoothly and give years of enjoyment.
Product are not intended for commercial use.
Customer Service: 1-866-397-9312
NOTE: When unpacking, lay the parts
on a padded surface such as the
packaging provided.
Be sure to locate all hardware before
throwing away any packaging.
E
F
G
10
2
1
Allen Bolts
Washer
Allen Wrench
(Top Tray)
A 1
B 1
C 1
D 2
(Handle)
(Bottom Tray)
(Stand)
Assembly
Safety & Care Instruction
Attaching the Stand Legs
To clean, wipe down the wood board and stand using a damp cloth and mild soap and warm water after each.
Dry immediately with soft cloth.
Always place product on a solid, level surface.
B
(Top Tray) E(Bolt)
F(Washer)
Place the bottom tray (C) on a soft, flat surface and
attached stand leg (D) to bottom tray (C) and align the
bolt holes on the bottom tray (C) with the holes on the
stand leg (D).
Loosely secure the stand legs (D) to the bottom tray (C)
with bolts (E).
D
C
(Bottom Tray)
D(Stand Legs)
E
(Bolt)
E(Bolt)
E
(Bolt)
Attaching the top tray
Attached top tray (B) to stand leg (D) and align the bolt
holes on the stand leg (D) with the holes on the top tray
(B).
Loosely secure the stand legs (D) to the top tray (B) with
bolts (E).
Once all of the bolts (E) are in place and the stand
assembly is aligned properly, tighten all bolts (E) with the
Allen Key (G).
Attaching the handle
Attached Handle (A) to top of stand legs (D) and align the
bolt holes on the stand leg (D) with the holes on the
Handle (A).
Secure the handle (A) to the top tray (B) with bolts (E) and
tighten with the Allen Key (G).
DD (Stand Legs)
C
(Bottom Tray)
E
(Bolt)
E
(Bolt)
B(Top Tray)
A
(Handle)
DD (Stand Legs)
/