2. DeWalt
  3. Pure110

DeWalt Pure110 User manual

  • Hello! I've reviewed the provided DEWALT Technical Bulletin regarding the Pure110+ and AC200+ Adhesive Anchoring Systems. This document outlines supplemental installation instructions, focusing on the cartridge balancing procedure, which is crucial for proper adhesive mixing and the transfer of the piston plug assembly. I’m ready to answer any questions you might have about this process or the product itself.
  • What color should the mixed Pure110+ product be?
    What color should the mixed AC200+ product be?
    What is the purpose of the cartridge balancing procedure?
    Is it necessary to replace the piston plug assembly with each new cartridge?
anchors@DEWALT.com Technical Bulletin 1
September 19, 2019
DEWALT Pure110+ and AC200+ Adhesive Anchoring and Post-Installed Reinforcing Bar Connection Systems
Supplemental Installation Instructions for Preparation of the Adhesive in Step #3: Cartridge Balancing
Cartridge adhesives must be properly mixed to achieve published properties for anchoring applications into concrete and masonry.
In accordance with the Manufacturer’s Printed Installation Instructions (MPII) the supplied mixing nozzle must be attached to the
cartridge. The cartridge is loaded into the recommended dispensing tool. Prior to dispensing adhesive into the drilled hole,
separately dispense at least three full strokes of adhesive through the mixing nozzle until the adhesive is a consistent color: product
must be Red color for mixed Pure110+ product or Gray color for mixed AC200+ product.
During consecutive installations using DEWALT piston plugs, it is permissible to transfer the piston plug assembly (nozzle, flexible
tubing extension and piston plug) to a new cartridge when the initial cartridge is depleted. For the transfer and continued use of
the piston plug assembly to be viable, the cartridge balancing steps shown below and restart of dispensing adhesive into the hole
must be completed within the published working time of the adhesive as provided in the MPII.
Procedure for Cartridge Balancing:
1. Remove piston plug assembly from the depleted cartridge.
2. Load a new cartridge into dispensing tool (without new mixing nozzle).
3. Remove cap and balance cartridge by dispensing adhesive until both components
are flowing separately and equally through the cartridge opening.
Suggest removing any excess adhesive from cartridge opening prior to the next step.
4. Attach nozzle of piston plug assembly to the balanced cartridge.
5. Resume dispensing and placement of adhesive into hole.
Step #3
Provided these steps are followed, replacing the piston plug assembly with each new cartridge is not necessary. This supplemental
procedure for cartridge balancing has been tested and determined to be equivalent to the standard procedures given in the MPII.
DEWALT
701 East Joppa Road
Towson, MD 21286
P: (800) 524-3244
anchors.DEWALT.com
/