DeWalt Pure110 User manual

Brand: DeWalt

Model: Pure110

Type: User manual

DeWalt Pure110 is a high-performance adhesive anchoring system designed for professional-grade applications. It excels in anchoring into concrete and masonry substrates, providing a strong and reliable hold for various construction projects. With its advanced formulation, Pure110 delivers exceptional bonding strength and resistance to vibration and dynamic loads. The system includes a mixing nozzle to ensure proper mixing of the adhesive components, resulting in a consistent and uniform mixture for optimal performance.

anchors@DEWALT.com Technical Bulletin 1

September 19, 2019

DEWALT Pure110+ and AC200+ Adhesive Anchoring and Post-Installed Reinforcing Bar Connection Systems

Supplemental Installation Instructions for Preparation of the Adhesive in Step #3: Cartridge Balancing

Cartridge adhesives must be properly mixed to achieve published properties for anchoring applications into concrete and masonry.

In accordance with the Manufacturer’s Printed Installation Instructions (MPII) the supplied mixing nozzle must be attached to the

cartridge. The cartridge is loaded into the recommended dispensing tool. Prior to dispensing adhesive into the drilled hole,

separately dispense at least three full strokes of adhesive through the mixing nozzle until the adhesive is a consistent color: product

must be Red color for mixed Pure110+ product or Gray color for mixed AC200+ product.

During consecutive installations using DEWALT piston plugs, it is permissible to transfer the piston plug assembly (nozzle, flexible

tubing extension and piston plug) to a new cartridge when the initial cartridge is depleted. For the transfer and continued use of

the piston plug assembly to be viable, the cartridge balancing steps shown below and restart of dispensing adhesive into the hole

must be completed within the published working time of the adhesive as provided in the MPII.

Procedure for Cartridge Balancing:

1. Remove piston plug assembly from the depleted cartridge.

2. Load a new cartridge into dispensing tool (without new mixing nozzle).

3. Remove cap and balance cartridge by dispensing adhesive until both components

are flowing separately and equally through the cartridge opening.

Suggest removing any excess adhesive from cartridge opening prior to the next step.

4. Attach nozzle of piston plug assembly to the balanced cartridge.

5. Resume dispensing and placement of adhesive into hole.

Step #3

Provided these steps are followed, replacing the piston plug assembly with each new cartridge is not necessary. This supplemental

procedure for cartridge balancing has been tested and determined to be equivalent to the standard procedures given in the MPII.

DEWALT

701 East Joppa Road

Towson, MD 21286

P: (800) 524-3244

anchors.DEWALT.com

DeWalt Pure110 User manual

DeWalt Pure110 User manual

DeWalt Pure110 User manual

Related papers

Other documents